Techno-Isel DaVinci Setup

INSTRUCTIONS: 1. Attach router mounting bracket as shown, using two short screws provided. 2. Mount router on bracket, then clamp into bracket by tightening long screw provided. bracket router nuts Z axis long screw short screw ...

Techno-Isel DaVinci Contact Techno immediately if any item is missing. � (1) DaVinci controller (#EP1090) � (1) Kress router (installed on 8'x8' DaVinci) � (1) router mounting bracket (installed on 8'x8' DaVinci) � (1) 6mm collet (installed on router) � (2) CAM clamps ...

RS232 port on DaVinci. If PC COM port has 25 pins, attach 9-25 pin adapter to 9-9 pin RS232 serial cable, and connect from 25 pin PC COM port to RS232 port on DaVinci. Use only specially wired RS232 serial cable provided. Refer to DaVinci Set-Up Manual for more detailed information ...

Techno-Isel DaVinci right leg of machine. Plug other end into 120VAC outlet. Make sure all axes on DaVinci are at least 1/2 inch away from the end of travel before turning on power to controller. To move axis off home sensor while power is off, turn knob at end of motor until axis has moved away. NO AXIS MAY BE ...