PR Lighting PR-2001L Quick Start Manual

installation and performance of the unit. When unpacking and before disposing of the package check there is no transportation damage before using the projector. Should there be any damage caused by transportation, consult your dealer and do not use the apparatus. Keep the package well fo ...

PR Lighting PR-2001L 3 CONSTRUCTION 4 FITTING THE LAMP 4 POWER SUPPLY – MAINS 4 OPERATION 5 STAND-ALONE MODE 6 XLR CONNECTIONS AND TERMINATOR 6 MASTER/SLAVE SYNCHRO MODE 7 CONTROLLER MODE - DMX OPERATION 8 MAINTENANCE 10 KEEPING THE PROJECTOR CLEAN 10 TROUBLESHOOTING 10 TECHNICAL DATA 11 ELECTRICAL DIAGRAM 12 Please note that as part of ...

PR Lighting PR-2001L use of this projector. Please read and follow these instructions carefully and keep this manual in a safe place for future reference. 571 Yingbin Road Dashi Panyu Guangzhou 511430, China http://www.pr-lighting.com ...

PR Lighting PR-2001L Optional: 240V, 220V AC 50/60Hz Power consumption: 2800W at 220V Lamp: MSA2500 DE, double ends Colour temperature: 5600°K Manufacturers Rated Lamp life: 2000 Hours Protocol: Standard DMX 512 Running mode: Stand-alone, Master/Slave, and DMX Controller DMX channels: 6 channels Colours: 3 basic colours, CYM 256 colours continuous mix ...

PR Lighting PR-2001L test. After finishing these, the apparatus is ready for operation. Remove the cover of the control panel, you will see the DIP switches with numbers from 1 to 4, and 3 rotary DIP switches for setting the start address and an LED display as shown in the figure belo ...

PR Lighting PR-2001L The following table lists the address codes setting from 1 to 80 lumanaires. (Actually, the 3 rotary DIP switches may set address of 167 luminaires in all.) The setting way is to turn the 3 tuning- wheel switches to let the arrows of the switches allign respectively to values as shown in the foll ...

PR Lighting PR-2001L protocol. You may use controller to control many luminaires via regulate the rotary DIP switches. (For detail please refer to “DMX start address setting table”.) 8/14 Regulate all DIP switches as shown in the figure on the right. Now, all the luminaires will work under the controller. Connect the contr ...

PR Lighting PR-2001L NAME PART NO. REMARK TRANSFORMER 040030022 230V/50Hz IGNITOR 040090004 230V/50Hz BALLAST 040070033 230V/50Hz RELAY 192010009 230V/20A FILTER 193020001 10A THERMOSTAT(2 pcs) 190010054 95 /10A FAN (4 pcs) 030069002 230V/23-24W LAMP FOR CENTURY COLOUR 2500 100050026 MSI 2500W LAMP FOR CENTURY COLOUR 2500L 100050042 MSA 2500 DE CAP (3 pcs) ...

PR Lighting PR-2001L terminator at the last fixture in the chain. This prevents electrical noise from disturbing and corrupting the DMX control signals. The DMX terminator is simply an XLR connector with a 120 (ohm) resistor connected across pins 2 and 3, which is then plug ...

lamp appears dim this would normally indicate that it is reaching the end of its life and it should be changed at once, old lamps run to the extremity of their life can explode. If the projector does not function, check the fuse in the projector base, it should onl ...