Texas Instruments RM46 Operation & User’s Manual

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fr ...

Texas Instruments RM46 SDRAM CAN1 ETM SPI/ADC JTAG POR RST PWR USB EMU EXP Conn1 SPI2 SD Slot XDS100V2 CPLD FTDI 2332 Ext JTAG EMIF/ ETM/ SPI2 ENET RJ45 ENET PHY MII/ RMII CAN PHY EXP Conn2 EXP Conn3 Pinmux DIP PIN MUX RM46L852 220 MHz PIN MUX CAN/ FRAY/LIN/ GIO/HET Light Sensor Temp Sensor CAN2 CAN PHY GIO Button 3.3V/5V A/D 3.3V I/O 1.2V Core USB PHY USBH USB PHY USB-D HDK Board ...

Texas Instruments RM46 Pin Number Signal Pin Number Signal 1 D0+ 2 D0- 3 D1- 4 D2+ 5 D2- 6 D1- 7 D3+ 8 D3- Two LEDs are embedded into the connector to report link status (green LED) and transmit and receive status of the PHY (yellow LED). 2.2.3 CAN Interface The RM46L852 has up to three DCAN interfaces that prov ...

changes to its semiconductor products and services per JESD46, latest issue, and to discontinue any product or service per JESD48, latest issue. Buyers should obtain the latest relevant information before placi ...

Texas Instruments RM46 】 This development kit is NOT certified as Confirming to Technical Regulations of Radio Law of Japan If you use this product in Japan, you are required by Radio Law of Japan to follow the instructions below with respect to this product: 1. Use this product in a shielded room or any other ...

Texas Instruments RM46 Texas Instruments (TI) provides the enclosed Evaluation Board/Kit/Module (EVM) under the following conditions: The user assumes all responsibility and liability for proper and safe handling of the goods. Further, the user indemnifies TI from all claims arising from the handling or use of the goods. Should th ...

Texas Instruments RM46 Those LEDs are controlled and programmed by NHET signals. LEDs DS2, DS3, DS4, and DS5 indicate the presence of the power (+1.2 V, +5 V, 3.3 V, and 12 V) s on the board. The LED functions are summarized in Table 2-9 and Tab ...

Texas Instruments RM46 1 Introduction ........................................................................................................................ 5 1.1 Scope of Document ............................................. ...

Read This First About This Manual This document describes the board level operations of the RM46 Hercules™Development Kit (HDK). The HDK is based on the Texas Instruments RM46L852 Microcontroller. The RM46 HDK is a table top card that allows engineers and software developers to evaluate certain cha ...

Texas Instruments RM46 Physical Description This section describes the physical layout of the RM46 HDK board and its interfaces. 2.1 Board Layout The RM46 HDK board is a 4.9 x 4.3 inch (125 x 109 mm) eight layer printed circuit board that is powered by an external +5 V to approximately +12 V only power ...