Desa AMITY SDVBPD Owner's Operation And Installation Manual

For more information, visit www.desatech.com 23 23 W R STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION Continued INSTALLING OPTIONAL WALL MOUNTED THERMOSTAT - GWMT1 WARNING: Installation must be done by a qualified installer familiar with low voltage wiring procedures. WARNING: Do not connect this th ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 33 33 Figure 65 - Blower Wiring Diagram for Thermostat-Controlled Models WIRING DIAGRAM CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 26 P I L O T O F F P I L O T O N TPTH TP TH HI LO IN OUT TO TURN OFF GAS TO APPLIANCE 1. Turn ON/OFF switch, located on side of rear cover, to “OFF”. 2a. Open lower door panel. 2b. If Using Optional Hand-Held Remote: Set selector switch, located on si ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 15 15 Horizontal Termination Configurations Figures 28 through 30 show different configurations for venting with horizontal termination. Each figure includes a chart with vertical minimum/maximum and horizontal maximum dimensions which must be met. Seal all c ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 28 Safety Features When away from home for an extended period of time or as a child safety feature to prevent accidental ignition of the fireplace, the receiver ON/OFF/REMOTE switch should be in the OFF position. Auto Shutoff Feature 1. If the average room te ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 11 11 Fixed Closed Openable Fixed Closed Openable V V V V V V V V X X V X G G J F B B K N H I A N E L D B M A C B V V A G G B TERMINATION CAP AIR SUPPLY INLET GAS METER RESTRICTED AREA (TERMINATION PROHIBITED) A = clearance above grade, veranda, porch, deck, ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 33 P I L O T O F F P I L O T O N HI LO IN OUT PRODUCT IDENTIFICATION Figure 1 - DESA Direct-Vent Burner System Shown Installed in Approved Cast Iron Stove Body (Oxford™ Model Shown) SAFETY INFORMATION PRODUCT IDENTIFICATION Cast Iron Stove Body Piezo Ignito ...

For more information, visit www.desatech.com 22 3. Check all joints from propane/LP supply tank or gas meter to equipment shutoff valve (see Figure 43 for propane/LP or Figure 44 for natural). Apply noncorrosive leak test solution to all gas joints. Bubbles forming show a leak. Correct all leaks at once ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 18 Venting with Two 90° Elbows Vertical (V1) Horizontal (H) 5' min. 6' max. 6' min. 12' max. 7' min. 18' max. 8' min. 20' max. Note: Vertical (V1) + Vertical (V2) = 20' max. Figure 37 - Vertical Venting Configuration Using Two 90° Elbows VENTING INSTALLATIO ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 32 TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s p ...

Desa AMITY SDVBPD For more information, visit www.desatech.com 24 4. Place receiver into valve bracket and align holes (see Figure 49). 5. Use push-in fasteners included with receiver to secure to bracket. 6. Connect the wires from the receiver to the valve at TH and THTP (see Figure 45, page 22). TPTH TP TH TPTH TP TH ...

For more information, visit www.desatech.com 16 1. Determine the route your vertical venting will take. If ceiling joists, roof rafters, or other framing will obstruct the venting system, consider an offset (see Figure 31) to avoid cutting load bearing members. Note: Pay special attention to these insta ...