STA-RITE Signature 2000 Owner's Manual

(refer to Figures 7 and 8) This procedure is best completed with the pump held in a vertical position, motor down. First complete “Disassembly” instructions 1 through 5 under “Impeller Stack Changeout.” (see Figure 7). 6. Remove 4 capscrews holding pump body to motor. Pump handle will come off with top capscrews. 7. Unscre ...

STA-RITE Signature 2000 line should be short and have as few elbows as possible. Size the inlet according to the chart below: An inlet strainer will prevent suspended debris from clogging pump. The internal running surfaces of the pump and seals require water lubrication for good, consistent operation. Allowing pump to run dry ...

STA-RITE Signature 2000 The high pressure booster pump has been carefully inspected and packaged to assure safe delivery. Inspect the pump and fittings and report to the carrier any items which are damaged or missing. INSTALLATION The pump is designed to boost city water pressure or water pressure from a private water system. Use this high pressure stream to wa ...

STA-RITE Signature 2000 7A Figure 9 – Exploded view. Hose 6’-3/4” w/Female Ends (150 PSI Rating) Pkg. 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) Pkg. 84 Adapter 3/4” NPT x 3/4” Hose Pkg. 85 Sprayer Gun Pkg. 87 Nozzle - High Pressure Pkg. 86 Suction Vacuum Relief Valve Pkg. 96 Hose 25’ - 1” ID with 3/4� ...

STA-RITE Signature 2000 Risk of electrical shock. 1. Be sure power is disconnected to motor when working on electrical connections. 2. Remove the motor end cover, exposing motor shaft. Momentarily start pump. If hookup is correct, the shaft will rotate clockwise. 3. If rotation is not clockwise, reverse any two leads to the starter. T ...

7A Figure 13 – Exploded view. Hose 6’-3/4” w/Female Ends (150 PSI Rating) Pkg. 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) Pkg. 84 Adapter 3/4” NPT x 3/4” Hose Pkg. 85 Sprayer Gun Pkg. 87 Nozzle - High Pressure Pkg. 86 Suction Vacuum Relief Valve Pkg. 96 Hose 25’ - 1” ID with 3/4� ...

STA-RITE Signature 2000 9 6A Figure 12 – Exploded view. Hose 6’-3/4” w/Female Ends (150 PSI Rating) Pkg. 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) Pkg. 84 Adapter 3/4” NPT x 3/4” Hose Pkg. 85 Sprayer Gun Pkg. 87 Nozzle - High Pressure Pkg. 86 Suction Vacuum Relief Valve Pkg. 96 Hose 25’ - 1” ID with 3/4” Ends ...

STA-RITE Signature 2000 9 6A Figure 10 – Exploded view. HPS7C-01 HPS7D-01 HPS7E-01 HPS7C3-01 HPS7D3-01 HPS7E3-01 HPS10C-01 HPS10D-01 HPS10E-01 HPS10F-01 HPS10G-01 Key HPS10C3-01 HPS10D3-01 HPS10E3-01 HPS10F3-01 HPS10G3-01 No. Description Qty. 1/2 HP 3/4 HP 1HP 1-1/2 HP 2 HP 1 Motor - 115/230 Volt, 1 Phase 1 A100CHL A100DHL A100EHL AE100FHL ...

REPAIR PARTS LIST Signature 2000 High Pressure Booster Pump 60 Hz. 1/2 through 3 HP STA-RITE INDUSTRIES, DELAVAN, WISCONSIN 53115 Printed in U.S.A. © 2003, Sta-Rite Industries S327 (Rev. 12/4/03) 1218 0894 NC ...

STA-RITE Signature 2000 power supply. Failure to ground motor can cause severe or fatal electrical shock hazard. Explosion hazard. Do not ground to a gas supply line. To avoid dangerous or fatal electrical shock, turn OFF power to motor before working on electrical connections. Supply voltage must be within ±10% of nameplate ...

STA-RITE Signature 2000 (see Figures 5 and 6). 1. Unplug the motor. 2. Loosen the two screws on the end of the motor. Gently pull the canopy from the motor. NOTICE: Do not pull or jerk wires. 3. Connect the green (or bare copper) ground wire to the green ground screw first. Use a solid copper wire at least as large as the power supply ...

STA-RITE Signature 2000 7A Figure 11 – Exploded view. Hose 6’-3/4” w/Female Ends (150 PSI Rating) Pkg. 83 Hose 25’-3/4” w/Male & Female Ends (150 PSI Rating) Pkg. 84 Adapter 3/4” NPT x 3/4” Hose Pkg. 85 Sprayer Gun Pkg. 87 Nozzle - High Pressure Pkg. 86 Suction Vacuum Relief Valve Pkg. 96 Hose 25’ - 1” ID with 3/4� ...