Solidyne WTS-DB Quick Start Manual

Solidyne 1 TECH/DATA SHEET WTS-DB Revision 1 12/2007 WTS-DB Digital Room Temperature Sensor The WTS family of Wall Temperature Sensors are designed to be used with the M2 family of Solidyne controllers. They are designed with a rugged ano ...

2 Wiring Cont’d CAT-5 Wiring: Jumper Configuration The WTS-DB has 3 jumper configurations. The default jumper position is JP2 only. Other jumper configurations are reserved for future use and not applicable at this time. CAT-5 Input Assignment: When using the CAT-5 wiring, the M2 controllers will automati- cally assign it’s in ...

Solidyne WTS-DB 3 Modes of Operation Cont’d Figure 8 In Mode 2, when the highest red LED is lit, the Virtual Input #1 will be +3. Giving the system an indication that the user would like the setpoint to be 3 degrees warmer than current. Furthermore, if the green LED is lit, Virtual Input #1 would be set to a value of zero (0). And when the low ...

Solidyne WTS-DB 4 © Copyright 2005 Solidyne Corporation All rights reserved. No part of this document may be photocopied or reproduced by any means, or translated to another language without prior written consent of Solidyne. All specifications are nominal ...