Technics SA-DA20 Operating Instructions Manual

14 RQT5861 For front speakers with an impedance under 6 Ω Turn “LOW IMP” on if even one of your speakers has an impedance under 6 Ω. Press and hold [A] or [B] until “LOW IMP” lights up on the display. Press and hold down again to cancel “LOW IMP”. Note that when “LOW IMP” is on, SPEAKERS A and B cannot be used at the same time. SPEAKERS A, B SPEAKERS A B LOW IMP SPEAKERS A ...

Remote control 28 RQT5861 Apart from the receiver, this remote control can also operate Panasonic or Technics cassette decks, CD players, MD decks, televisions, video decks and DVD players, provided they have remote control sensors. ¡For details on operating other equipment, see the instruction manual provided with the specific unit. ¡Some models cannot be operated by this remote control. ¡Actual operations depend on your equipment and software. You can also change the remote control code to operate televisions, video decks, and DVD players manufactured by oth ...

To select an input source and switch the remote control to each operation mode To adjust the volume To select the DSP sound mode (⁄8) To select the SFC mode (⁄8) To start a test signal (⁄5) To select the speaker channel and adjust its output level (⁄5, ⁄7, ¤1) To adjust subwoofer output level (¤1) To change the surround channel delay time (⁄7) To dim the display (¤6) To select “FM” or “AM” (¤2) To change radio channels sequentially (¤3) (Preset tuning) To select radio channels directly (¤3) (Preset tuning) Reference pa ...

12 RQT5861 Change the settings to suit your speakers and equipment and to suit the environment in which the unit is to be used. Before making any changes, read the following descriptions, note the factory settings and ranges, and refer to the instructions for the speakers and equipment. The settings remain intact until they are changed, even after the power is turned off. Setting descriptions SIZE Change to suit the speakers you have connected. LARGE: For speakers that can reproduce a full sound range, particularly the bass range below 100 Hz. SMALL: For speakers that ...

5 RQT5861 Before use TUNED STEREO MONO LOW IMP EON PS PTY RT kHz MHz PRO LOGIC PROGRAM FORMAT DIGITAL WAKE SLEEP SOUND MODE STEREO SURROUND SFC L C R LS S LFE RS A B BI-WIRE M RDS SPEAKERS A B BI-WIRE VOLUME MIN MAX DIGITAL TUNING MEMORY DISPLAY MODE-PTY SEARCH WAKE BAND FM MODE EON RDS DSP SOUND MODE VGCA ON VIA TONE MIN MAX MIN MAX L R BALANCE TREBLE BASS VCR 2 VCR 3 VIDEO IN L AUDIO IN R TAPE MONITOR DIGITAL INPUT PHONES TIMER 1 3 4 2 5 6 7 8 9 10 11 13 14 15 18 19 20 22 21 23 24 25 26 27 28 12 BI-AMP DVD 6CH INPUT INPUT SELECTOR VCR 3 29 30 31 32 33 35 34 36 38 37 ...

14 RQT5861 For front speakers with an impedance under 6 Ω Turn “LOW IMP” on if even one of your speakers has an impedance under 6 Ω. Press and hold [A] or [B] until “LOW IMP” lights up on the display. Press and hold down again to cancel “LOW IMP”. Note that when “LOW IMP” is on, SPEAKERS A and B cannot be used at the same time. SPEAKERS A, B SPEAKERS A B LOW IMP SPEAKERS A ...