Flymo Hover Vac Original Instructions Manual

& retain for future reference For all customer enquiries or for replacement parts, contact:-
01325 300303 www.flymo.com [email protected] Hover Vac Original Instructions ...

• Use only 1.00mm2 size cable up to 40 metres length maximum. Maximum rating : 1.00mm2 size cable, 10 amps 250 volts AC. THE HOVER VAC IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT 1. Flymo Mains Cables and Extension Cables are available from your local Approved Service Centre. 2. Do not wire an extension cable directly to you ...

Flymo Hover Vac IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 01325 300303, Fax : 01325 302530 Safety If not used properly this product can be dangerous! This product can cause serious injury to the ...

Flymo Hover Vac 1. Is the Power Turned On? 2. Check the fuse in the plug, if blown replace. 3. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Poor Flotation 1. Disconnect from the mains electricity supply. 2. Clean the underside of the hood and the fan blades. 3. Raise to a hi ...

Aycliffe Industrial Park NEWTON AYCLIFFE Co.Durham DL5 6UP ENGLAND Telephone - (00) 44 1325 302302 Fax - (00) 1325 310339 Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. EC Declaration of Conformity Husqvarna UK Ltd., Aycliffe Industrial Park N ...

Flymo Hover Vac 1. Place the ends of the lower handle into the slots 2. Secure lower handle to hood by firmly pushing fixing pin through holes in hood and handle (A1). 3. Repeat on the other side. • NOTE Should a problem occur when securing handle with the fixing pin, carefully lever the pin out of location and re ...

Flymo Hover Vac within the guarantee period, Husqvarna UK Ltd., through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a)The fault is reported directly to the Authorised Repairer. (b)Proof of purchase is provided. (c)The fault is not caused by mi ...

Flymo Hover Vac sharp edges could cause injury. USE GLOVES. Checking your Cutting System (R) • The cutting system must be kept in good condition and inspected before and after use. • Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down. 1. Vi ...

Flymo Hover Vac L M 1 2 3 3 2 1 HIGHEST This symbol visible LOWEST This symbol visible J K THERE ARE 2 CUTTING HEIGHTS (J & K) • Height of cut is adjusted by turning over the cutting head. • Disconnect from the mains electricity supply and wait until the cutting head has stopped rotating. Turn your product upside down. • To Remove the Cutt ...