National Instruments NI REM-11100 Getting Started Manual

Error E1 LED E2 LED No error Off Off Underrange Off On Overrange Off On Supply voltage faulty (supply for analog modules UA) On On Parameter table invalid Off On Device error Off On Flash format error Off On Note The reported error depends on the measuring range. For information about input scaling, refer to the device datasheet on ni.com/manuals. Connecting the REM-11100 Figure 4. REM-11100 Voltage Measurement Connection 24 VDC AI+ (0:3) AI– (0:3) UIS (0:3) GND 24 VDC Sensor GND x4 REM-11100 + – + – a1 a2 b1 b2 UIS and GND are optional, sensor-de ...

mounting the module. 1. Align the REM-11100 over the appropriate bus connector. Note Verify that the bus connector socket aligns with the socket on the underside of the module. 2. Press the REM-11100 directly onto the bus connector and DIN rail until it clicks into place. Caution Tilting the module when mounting it on the DIN rail will damage the contacts. Installing Spring-Terminal Blocks What to Use • REM-11100 • Spring-terminal block What to Do Align the spring-terminal block over the REM-11100 and pre ...

• Make sure that devices you connect to the REM-11100 are compatible with the module specifications. • Push the wire into the terminal when using a solid wire or a stranded wire with a ferrule. • Open the terminal by pressing a screwdriver into the spring lever when using a stranded wire without a ferrule. Removing Components Removing Spring Terminal Blocks Complete the following steps to remove a spring-terminal block from the REM-11100. 1 3 2 1. Press the locking latch to release the spring-terminal blo ...

mounting the module. 1. Align the REM-11100 over the appropriate bus connector. Note Verify that the bus connector socket aligns with the socket on the underside of the module. 2. Press the REM-11100 directly onto the bus connector and DIN rail until it clicks into place. Caution Tilting the module when mounting it on the DIN rail will damage the contacts. Installing Spring-Terminal Blocks What to Use • REM-11100 • Spring-terminal block What to Do Align the spring-terminal block over the REM-11100 and pre ...