Technogym Element+ Operation & User’s Manual

To replace the cable, proceed as follows: - remove the back panel of the weight stack (following the instructions found in the section Removing the weight stack panel); - loosen the screws (A) on the tie rod (B); - back off the lock nut (C) and unscrew the adjuster (D); - extract the cable from the adjuster side; ...

Technogym Element+ WArnInG When lifting the equipment, do not exert pressure against the weight stack guards. ...

Technogym Element+ - insert a thickness of approx. 10 mm (1/2”) under the first weight of the weight stack; - screw in the screws (A) on the tie rod (B); - remove the 10 mm (1/2”) thickness from the weight stack; - screw in the adjuster (D) in order to adjust the cable tension and tighten the lock nut (C); - replace the back panel of ...

Technogym Element+ It is possible to take up some of the slack in the weight stack cable using the adjuster (D), after loosening the lock nut (C). For this purpose, you will need to remove the back panel of the weight stack (following the instructions found in the section Removing the weight stack panel). WArnInG To pull the cable taut ...

Technogym Element+ The weight stack panel is attached to the frame with 6 screws. To disassemble the panel (A): - unscrew the 6 screws (B) while holding the panel with one hand; - remove the panel. To reassemble the panel, carry out the above steps in reverse order. ...

Technogym Element+ Seat (A): where the user sits to perform the exercise. Its position can be adjusted using the seat lever (B). Exercise levers (C): operated by the user by means of the handgrips (D). Chest pad (E): the user’s chest rests against it during the exercise. Fixed handgrip (F): can be grasped with the re ...

Technogym Element+ After the equipment has been positioned on the floor, check that it is level. The foot (A) is adjustable for this purpose: loosen the lock nut (B) and tighten or loosen the foot until the equipment is stable. When this is done, close the lock nut (B). ...

If any of the padded components show signs of wear, it is advisable, especially in the interests of hygiene, to replace them completely. In order to replace the seat loosen the screws on the opposite side to the padding. Handgrips are removed after unscrewing the screws (A). In order to replace the chest pad lif ...

Technogym Element+ To guarantee safe, comfortable and effective use of the equipment, the place of installation must comply with certain specific requirements; in particular, before choosing where to install the equipment it is recommended to check the following: - temperature between +10°C and +25°C; - sufficient ventilation to maintain a hum ...

The equipment does not have any sharp corners. All the parts which come into contact with the body are adequately protected with rubber coverings or padding. The weight stack is enclosed in protective panels. WArnInG It is important to pay attention to the labels affixed to the equipment, as ...

Technogym Element+ - remove the back panel of the weight stack (following the instructions found in the section Removing the weight stack panel); - use a soft cloth to remove any dust and oil residues from the guides; - slightly moisten the cloth with the oil supplied; - using this cloth, apply a very thin la ...