Arzel RegiDamper Manuals

Arzel® Zoning Technology, Inc. RegiDamper™ Installation Instructions Application The Arzel® RegiDamper™ is used where the branch ducts are inaccessible in finished ceilings or in slabs, which prevent the use of the original Arzel® EzySlide™ dampers. The RegiDamper™ is installed in the register boot just behind the register and is operated by a low pressure air and vacuum pump (contained in the Arzel® panel) by way of a 1/4 inch plenum rated Dekoron (UL Rated) tubing. Installation Preparation • Remove all registers and fit damper assemblies into boots with tubing connection facing into the duct opening (see fig. 1-a). • Once damper fit is verified, remove dampers from boot. Fig 1-a: Inserting RegiDamper™ © Copyright 2004 Arzel Zoning Technology, Inc. All Rights Reserved U.S. and Foreign Patents and Patents Pending fig. 1-a - Fitting damper into boot • Cut an opening in the main trunk large enough to view the take-offs of the runs you are zoning with RegiDampers. Locate the opening as close to the take-offs as possible. Tape the cut edges of the opening with duct tape to prevent cutting yourself.