Clarke Super 7R Manuals

56043142 Page 1 MODELS: 07125A, 07126A, 07013A

Super 7R Edger Operation and Safety Safety Practices: Sanding dust is flammable! Empty and clean dust bag when not in use. Always wear safety goggles, protective clothing, and a dust mask while sanding. Keep the work area well ventilated. Sanding/finishing wood floors can create an explosive or combustible environment. Do not operate this machine around solvents, thinners, fuels, floor finishes, or any other flammable materials. Keep hands, feet, and loose clothing away from all moving parts on the machine. Disconnect the power cord before replacing the pad or the abrasive. Never leave the machine unattended while it is connected to a power source. www.clarkeus.com/rental Application: Sanding wood floors along edges where a drum sander cannot reach. Install the Sandpaper Disc Step Action 1 Unplug the machine and turn it upside down. 2 Using the wrench accessory, remove the screw and washer from the center of the sanding pad. 3 Remove the center from a sandpaper disc. 4 Install the screw and washer in the center of the disc. Make sure the head of the screw is on the abrasive side of the disc. 5 Install the sandpaper disc on the sanding pad. 6 Tighten the screw until it is secure. Do not over-torque. Sanding a Wood Floor Follow the steps in the table below to sand the edges of a wood floor. Step Action 1 Move the machine to the work location and tilt the machine back so that the sandpaper does not touch the floor. Make sure the ON/OFF switch is in the OFF position. 2 Connect the electrical plug to a 3-prong outlet. More on reverse . . .

Form No. 70895A 1/07 Printed in the U.S.A. Super 7R DC Edger Operator's Manual Manual del operador Manuel de l’utilisateur This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your Clarke American Sanders machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. If your operator(s) cannot read this manual, have it explained fully before attempting to operate this machine. All directions given in this book are as seen from the operator’s position at the rear of the machine. For new books write to: Clarke® , 2100 Highway 265, Springdale, Arkansas 72764. English (2 - 11) Español (12 - 21) Français (22 - 30) ES EN FR READ THIS BOOK LEA ESTE MANUAL LISEZ CE MANUEL

Form No. 70895A 6/09 revised 7/09 Super 7R DC Edger Operator's Manual Manual del operador Manuel de l’utilisateur This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your Clarke American Sanders machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. If your operator(s) cannot read this manual, have it explained fully before attempting to operate this machine. All directions given in this book are as seen from the operator’s position at the rear of the machine. English (2 - 11) Español (12 - 21) Français (22 - 30) ES EN FR READ THIS BOOK LEA ESTE MANUAL LISEZ CE MANUEL