Document Preview & Text Transcription
www.fanvil.com
7JEFP%PPS1IPOF
2VJDL*OTUBMMBUJPO(VJEF
i33V
i33VF
1) Panel
%FWJDFTJ[F
Video Door Phone
Quick
Installation Guide
Connector
Mounting Template
295 x 142 x 62 (mm)
IR LED
Speaker
Camera
Numeric keypad
(password and dialing)
RFID area
RFID Card
Screw and Wrench
Photoresistor
LCD
Function key
Package Contents
www.fanvil.com
i33V
i33VF
7JEFP%PPS1IPOF
2VJDL*OTUBMMBUJPO(VJEF
Mounting dimensions
Unit:MM
Physical specification
MIC
Mounting dimensions
Mounting dimensions
Unit:MM
i33V
i33VF
2) Interface description
LCD
Status
Description
Status
Description
Connected to the Internet
SIP register success
Connected to the TR069
Lock off
Fault prompt 1 (with error
number)
Call failed (no response)
Dialing
Not connected to the Internet, flashing
SIP register fail, flashing
Not connected to the TR069, flashing
Lock on
Fault prompt 12 ?: flashing)
Ringing
Open the door
LCD
Function Key
Call Key, Enter the number and press C to dialing out.
C
K
Key
Description
Password mode,“K password # ”
B
Numeric keypad
Backspace Key, Enter the number and press B to delete
Input password or dialing
Open the rear case of the device, there is a row of terminal blocks for connecting
the power supply, electric lock control, etc. The connection is as follows:
ʒ
ʓ
ʔ
ʕ
ʖ
ʗ
ʘ
ʙ
ʚ
ʛ
ծ
Ethernet interface: standard RJ45 interface, 10/100M adaptive, it is recommended
to use five or five types of network cable
Description
Serial number
Two sets of short-circuit input detection interfaces: for connecting switches, infrared
probes, door magnets, vibration sensors and other input devices
Short circuit output 1: drive / short circuit output configurable
Short-circuit output 2: corresponding to the short-circuit input interface, login device
webpage setting, can be connected to the electric lock, alarm device, etc.
Wiegand interface
Two sets of door magnetic detection
Temperature control power interface: 12V/1A input
Power interface: 12V/1A input
JP1 jumper
ծ
JP1 Jumper
There are two modes for power supply of electric-lock as shown in the picture below.
(The default is “Passive Mode:”).
Passive Mode: When the electric-lock starting current is more than 12V/500mA, need to use the
external drive mode, the electric lock interface for short circuit output control.
Active Mode : When the electric-lock starting current is less than 12V/500mA, can use the internal
drive mode, the electric lock interface is 12V DC output.
+VNQFSJOQBTTJWFNPEF
+VNQFSJOBDUJWFNPEF
CN2
CN3
CN16
CN17
CN19
CN4