FingerTec H2i Manuals

Back Plate 4 feet / 1.2 meter (recommended) H2i s u p p o r t @ f i n g e r t e c . c o m H2i s u p p o r t @ f i n g e r t e c . c o m Back of Terminal For NC or NO door lock system GND BUT SEN NO COM NC ACCESS CONNECTIONPORT DC12V Power Supply +12V GND POWER SUPPLYPORT RS485 CONNECTION PORT 1. Single Connection 2. Network Connection +12V IWD1 IWD0 RLED GLED BEEP GND WIEGAND INPUT CONNECTION PORT 3rd party controller with 26 bits wiegand output WIEGAND OUTPUT CONNECTION PORT WD0 WD1 TCP/IP PORT (Ethernet Connection) - TCP/IP 485A 485B 485A 485B 485A 485B RX+ RX- RS485 Data Converter RX+ RX- RS485 Data Converter 3rd party controller with 26 bits wiegand output Step 1 Determine the Location and Positioning of the Installation • Avoid installing the terminals in locations with high moisture or condensation levels in the air • The recommended installation height of the terminal from the ground is 1.2 meter. Step 2 Mounting of Terminals on A Wall • After determining the height of the terminal from the ground level and have made the relevant marks on the wall, drill the screws into the wall to hang the back plate. Refer to Appendix II for dimensions and measurements of instal- lation. Installation Guides We Make Things Easy w w w . f i n g e r t e c . c o m H2i Door Access & Time Attendance System Step 3 Wiring for Power Supply The power input ports for these models are located at the rear of the terminals. There is no adapter plug supplied with the models, instead you need to source for power cable (red and black cables) to connect the power from the terminal to the AdapTec.

Simple Fingerprint Door Access & Time Attendance System User Guide H2i s u p p o r t @ f i n g e r t e c . c o m H2i