Fortin EVO-ONE RF442W Manuals

ALL-IN-ONE DATA INTERFACE REMOTE STARTER / ALARM QUICK INSTALLATION GUIDE D C B H I J (6-PIN) BYPASS RELAY (5-PIN) CAN-BUS (4-PIN) RS-232 DATA-LINK & FLASH-LINK UPDATER PORT BYPASS PROGRAMMING BUTTON REMOTE STARTER PROGRAMMING LED CUT LOOP FOR AUTOMATIC TRANSMISSION MODE. Red White Blue Blue Black LED Blue CAN ACTIVITY LED Yellow IGNITION ON LED Red BYPASS DATA E6 A F G E (+) Foot Brake Black In 750mA (-) Parking lights Pink Out 750mA (-) Trunk Release / AUX Yellow/Black Out (-) Hand Brake Brown/White In (-) Hood/Door Pink/Black In Bypass config. Purple/Yellow Bypass config. Green/White Bypass config. Green/Red Bypass config. White/Black Out Bypass config. Lt.Blue Ground Black In (+) Ignition Pink Out (+) Starter Yellow Out Out White (+) ParkLight/IGN2 /ACC/START Programmable Output (FUNCTION 2 & 31) Out Orange (+) ACC / IGN2 Programmable Output (FUNCTION 2 & 31) In Red (+) 12V In Yellow (+) Bypass Ignition Out Purple (-) Lock 750mA Out Purple/White (-) Unlock 750mA Out Green (-) Ignition 750mA Out White (-) Start 750mA Out Orange (-) Disarm 750mA Out Orange/Black (-) Horn/Siren 2 Amp Out Dk.Blue (-) GWR / Programmable 750mA In Red/Blue Bypass config. Lt.Blue/Black Bypass config. 750 mA MAXIMUM OUTPUT. Do not exceed the maximum current or permanent damage to the module will occur that will not be covered under warranty. (6-PIN) POWER CONNECTOR (20-PIN) SECONDARY CONNECTOR COPYRIGHT © 2014-2017, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED MADE IN CANADA REV.:20170323 A1 E1 (3-PIN) Shock Sensor (2-PIN) Valet/Programming Button A20 WIRING / CONNECTION GUIDE PROGRAMMING REMOTE TRANSMITTER(S) Black White White White (4-PIN) ANTENNA (4-PIN) DATA-LINK ANTENNA REMOTE STARTER FIRMWARE VERSION 1. [21] ET PLUS The system can learn up to a maxi- mum of 4 transmitters. Any transmitters can be stored in more than 1 memory slot. When a 5th transmitter is learned the 1st remote is erased (FIFO). STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 STEP 6 WITH IGNITION SWITCH Turn the Ignition OFF. Turn the Ignition ON. FMH 2-W The LED will turn ON x4 Press and release the brake pedal four times. FMH 2-W Turn the Ignition ON. WITH VALET SWITCH Press and hold the valet switch until the park- ing lights turn ON, the horn/ siren will chirp. x5 Press and release the valet switch five time. The parking lights will flash and the horn/siren will chirp each time to confirm. x1 Press and re- lease the brake pedal once. The LED will flash rapidly. On each Transmitter press and release the button then press and release the button. The LED will stop flashing confirming programming. Turn the Ignition OFF to exit programming. 1 3 2 4 EVO-ONE EVO-ONE download the specific vehicle installation guide, user guide or the latest quick installation guide at: www.fortin.ca RF442W GUIDE # 33051