Ultra Start 1150 Series Install Manual

-The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle. - CARBON MONOXIDE - Never Start in an Enclosed Building (Gar ...

Page 2 If the remote starter has a failed start attempt or if a safety input is activated the Diagnostic Memory will store up to four shutdowns in memory. This information can then be accessed to determine the source of the shutdown. To Enter Diagnostic Mode: Step 1 - Turn the ignition on wait two seconds then turn ...

INSTALLATION MANUAL Page 3 The jumpers control the output from the white wire from the six pin harness. Place the jumpers in the following order to change the output. Note: The default setting is second ignition. * Connect only one of these wires for remote start activation. The input requires 2 pulses within 2 seconds to activate. Pos ...

Yellow Starter 30amp output 12volts during crank only. Green Heater 30amp output 12volts in accessory off during start. Red 12 power 30amp input Constant 12volt power at ignition harness. Red 12 power 30amp input Constant 12volt power at ignition harness. Blue Ignition 1 30amp output 12volts in ...

INSTALLATION MANUAL Page 5 Yellow Starter Output Connect To The Vehicles Starter Wire. Green Heater Output Connect To The Vehicles Accessory Wire. Red 12 power Input Connect to Constant 12 Volt Power Source- High Current. Red 12 power Input Connect to Constant 1 ...

Programming Overview Entering Program Mode Changing the Programmable Settings SYSTEM RESET Program mode allows you to adjust the settings and options of your system. Your system has been intelligently designed by installers with years of experience. The system’s default settings do not require any program c ...

INSTALLATION MANUAL 1 Type 1 1 Flash Pulse after start and with lock 2 Type 2 2 Flashes Pulse after start only 3* Factory Re-arm 3 Flashes 0.75 second pulse with lock and after shutdown Press the Program Button 3 times to select setting 3 (This will be confirmed by 3 LED flashes) Press and hold the Program Button u ...

1Tach Detection Mode 1 Flash Set for Tach Detection - Must Connect Tach Wire *2Tachless Mode 2 Flashes No Tach connection required Press the Program Button 6 times to select setting 6 (This will be confirmed by 6 LED flashes) Press and hold the Program Button until you receive the appropriate # of park light ...