Gems Warrick RA-431 Series Manuals

Warrick® Series RA-431XX Remote Alarm Panel Installation and Operation Bulletin Form 431 Sheet P/N 100406-1 Rev. C This bulletin should be used by experienced personnel as a guide to the installation of Series RA-431 Remote Alarm Panels. Selection or installation of equipment should always be accompanied by competent technical assistance. You are encouraged to contact Gems Sensors or one of its local sales representatives for additional information. Caution The RA-431 Series panel and the remote switch must be located in a non-hazardous area. If the remote switch is located in a hazardous location, use a TA-730 Series or appropriate panel. Contact Gems Sensors for further assistance. 1. Mount the RA-431XX panel on a wall or other solid object with 4 (four) #8 or appropriately-sized screws. 2. Incoming Power: 3-Wire, 120 VAC Supply, Class I circuit 3. Remove switch, 2-wire dry contact 4. All wiring shall be in accordance with N.E.C. and local codes. Installation AC Version: 1,000 feet based on 14 or 16 gauge MTW or THHN wire DC Version: 5,000 feet based on 14 or 16 gauge MTW or THHN wire Maximum Sensor Wire Run Specifications Supply Voltage: 120 VAC +10%, -15%. 4.8 VA, Max Indicators: Red, green and yellow solid-state LEDs Audible Alarm: Field adjustable from 77 to 97 dB @ 2 feet by rotating shutter Enclosure: Weather tight polycarbonate (6.25h X 3.25W X 3.5d) Sensor Voltage: DC Version: 12 VDC, AC Version: 12 VAC Terminals: Size 6 pan head screws with captivated wire clamping plate Temperature: -22°F to 150°F, Ambient Sensitivity/AC Version: 0-26K ohm maximum specific resistance Listings: UL Listed, Industrial Control Equipment (508) Conduit Connection: 3/4” NPT, PVC material 148mm (5.826”) 160mm (6.299”) 50mm (1.968”) 80mm (3.149”) Four Outer Holes for Lid 3/4” NPT Depth of Enclosure with Lid Attached to Front Edge of Horn is 97mm (3.88”) Installation Diagram View with Lid Removed 38 mm (1 1/2”)