Visonic SMD-426 Installation Instructions Manual

Smoke Detector Installation Instructions 1. INTRODUCTION SMD-426 (smoke detector) and SMD-427 (heat and smoke detector) are automatic fire detectors with integral audible signal for open area protection, designed to sense heat or smoke (not flame) and fitted with a PowerG type transceive ...

2. Rotate the detector anticlockwise and pull it from the bracket A. BRACKET B. DETECTOR Figure 2. Separating the Detector from Its Bracket 3.2 Where to Install Smoke Detectors Smoke detectors should be installed in accordance with the NFPA Standard 74 (National Fire Protection Association, Batterymarch Pa ...

vicinity, but outside the bedrooms), and (2) Heat or smoke detectors in the living rooms, dining rooms, bedrooms, kitchens, hallways, attics, furnace rooms, closets, utility and storage rooms, basements and attached garages." 3.3 Where Not to Install Smoke Detectors False alarms ...

B. Open battery cover and connect the battery to its terminals (without insulator). Verify proper polarity. C. Battery cover D. Enroll button E. Tamper switch Figure 9a. Battery Connection for CR123A B C D A E A. 3 volts CR17450 B. Battery cover C. Enroll button D. Tamper switch E. Open battery cover and connect the bat ...

5. MODIFY DEVICE SETTINGS This section describes how to configure the parameters of the smoke detector from the PowerMaster-10 control panel. To Modify the Smoke Detector Device Settings Refer to the PowerMaster-10 Installer Guide and perform the procedu ...

Note: If the detector is not in local diagnostics or installer diagnostics mode, the detector will not perform the link quality test. D. At the end of the diagnostics test the LED blinks 3 times. The following table indicates received signal strength indication. LED response Reception Green LED b ...

9.1 Battery Replacement The SMD-426 and SMD-427 were designed to be as maintenance-free as possible. To keep the smoke detector in good working order, you must test it weekly, as instructed in Para. 6.1 below. Make it a rule to replace the detector’s battery (lithium) once every 8 years even if there is n ...

WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment The digital circuit of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules ...