Gesipa Olympic RV74G Manuals

Olympic Installations Tools 126 Quality Drive Mocksville, NC 27028 Phone: 336-751-1555 Fax: 336-751-0303 INSTRUCTIONS FOR THE USE AND MAINTENANCE FOR THE RV74G INSTALLATION TOOL (Formerly the RV73G tool) Description: The Olympic Model RV74G is an electric installation tool recommended for the installation of Olympic fasteners. It operates on 120VAC 60Hz. Pulling heads corresponding in size with the diameter of fasteners to be installed must be attached to the RV74G tool. Heavy-duty snap-on series pulling heads are available and capable of installing 1/8” to 9/32” Bulbtite Olympic Fasteners. Other pulling heads may be used in combination with the correct adapter. Operation: Attach the snap-on series pulling head to the installation tool in the following manner: actuate the installation tool until the draw bolt is in the extreme forward position. Thread the pulling head draw bolt fully to the installation tool draw bolt (Assy. 8023). Lift the spring band (3143). Slide the pulling head housing into the tool nose sleeve. Release the spring band (3143). The tool is now ready for operation. Fasteners are installed with the Olympic RV74G installation tool by first placing the fasteners into the holes of a prepared panel or sheet. Then apply the pulling head nose onto the fastener stem sliding the pulling head to the flange of the fastener. Then activate the tool by squeezing the motor trigger. Depending upon the application, the fastener may first be inserted by hand into the pulling head nose where it may be held in place by the head mechanism. Then the shank portion of the fastener can be inserted into the prepared holes prior to activating the installation tool. The pulling action is a continuously reciprocating one. The pulling head jaws will grip the fastener stem repeatedly as the installation tool moves the draw bolt back and forth. In the instance of long fasteners, the bolt may reciprocate several times before the fastener stem is broken.