Toro RP-500 Operator's Manual

RP-500/700/1200 Reversible Plate Compactor Model No. 68071—Serial No. 313000001 and Up Model No. 68072—Serial No. 313000001 and Up Model No. 68073—Serial No. 313000001 and Up Register at www.Toro.com. Original Instructions (EN) *3377-539* A ...

This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. Use of this product may cause exposure to chemicals known to the State of California to cause cancer, birth defects, or oth ...

Safety ........................................................................... 3 Safe Operating Practices........................................... 3 Safety and Instructional Decals ................................. 5 Setup ............................................................................ 7 Checking the Engine Oil Level ............................... ...

• Check that the operator's presence controls, safety switches, and shields are attached and functioning properly. Do not operate unless they are functioning properly. Operation • Never run an engine in an enclosed area. • Only operate in good light, keeping away from holes and hidden hazards. • Do not operate in standing water. • Slow down and use caution when making turns. • Ensure that the area ...

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 125–8182 1. Slow 3. Fast 2. Variable speed control 125–8207 1. Engine oil 93–9084 1. Lift point 125–8206 1. Caution 3. Read the Operator’s Manual for information on lifting the machine. 2. Do not lift the compactor by the handle. 5 ...

to move the compactor forward. 2. Pull the handle backward to move the compactor backward. 117–2718 125–4943 1. Warning—read the Operator’s Manual. 4. Warning—keep away from moving parts; keep all guards and shields in place. 2. Warning—wear hearing protection. 5. Choking hazard—do not operate the machine indoors. 3. Warning—check engine oil level before operating the machine. 6. Explosion hazard—stop ...

The machine comes from the factory with oil in the engine crankcase; however, it may be necessary to add oil. Refer to Servicing the Engine Oil (page 14). Add only enough oil to raise the level to the Full mark on the dipstick. Checking the Eccentric Oil Level The machine comes from the factory with eccentric oil in the eccentric housing; however, it may be necessary to add oil. Refer to Servicing the Eccentric Oil (page ...

4. Air cleaner 2. Throttle control 5. Recoil start handle 3. Lift point Figure 6 1. Recoil starter 4. Choke lever 2. Sediment cup 5. Throttle lever 3. Fuel shut-off valve 6. Engine On/Off switch Specifications Model Number RP-500 RP-700 RP-1200 Width 40 cm (15.7 inches) 50 cm (19.7 inches) 60 cm (23.6 inches) Length 118 cm (46.5 inches) 128 cm (50.8 inches) 142 cm (55.9 inches) Height (handle raised) 109 cm (42.9 ...

from the normal operating position. Checking the Engine Oil Level Service Interval: Before each use or daily 1. Stop the machine on a level surface. 2. Set the throttle to slow, turn off the engine switch, and wait for all moving parts to stop. 3. Clean around the dipstick (Figure 7) so that dirt cannot fall into the filler hole and damage the engine. Figure 7 1. Dipstick 4. Unscrew the dips ...

electricity can be released causing a spark which can ignite the gasoline vapors. A fire or explosion from gasoline can burn you and others and can damage property. • Always place gasoline containers on the ground away from your vehicle before filling. • Do not fill gasoline containers inside a vehicle or on a truck or trailer bed because interior carpets or plastic truck bed liners may insulate the c ...

Engine Starting the Engine 1. Move the fuel valve to the On position (Figure 10). g019704 1 Figure 10 1. Fuel valve 2. Move the engine switch to the On position (Figure 11). Figure 11 1. Engine switch 3. Move the choke lever to the left if you are starting a cold engine (Figure 12). Note: A warm or hot engine may not require choking. g019774 1 Figure 12 1. Choke 4. Slowly pull the recoil handle until you encounter resistance, then ...

Note: The compactor will begin vibrating when the throttle lever is set to maximum throttle. Figure 13 1. Throttle lever Stopping the Engine 1. Move the throttle control lever to the slow position (Figure 14). Figure 14 1. Throttle lever 2. Turn the engine switch and fuel valve off. Operating the Compactor Controlling the Direction of Travel • The travel control lever automatically moves forward and the mac ...

Maintenance Service Interval Maintenance Procedure After the first 25 hours • Change the engine oil. Before each use or daily • Check the engine oil level. • Clean debris from the air cleaner. • Inspect the air cleaner elements. Every 50 hours • Clean the air filter elements. Clean them more frequently in dusty operating conditions. Every 100 hours • Change the engine oil. • Adjust the belt. • ...

Note: Be careful to prevent dirt and debris from falling into the base. 6. Remove the foam and paper elements from the base (Figure 18). 7. Remove the foam element from the paper element (Figure 18). 8. Inspect the foam and paper elements, and replace them if they are damaged or excessively dirty. 9. If the paper element is excessively dirty, replace it. Note: Never try ...

to drain the oil. 4. When the oil has drained completely, replace the plug. Note: Dispose of the used oil at a certified recycling center. 5. Remove the dipstick (Figure 7) and slowly pour oil into the filler hole until the oil pours out of the filler hole. 6. Replace and secure the dipstick. 7. Wipe up any spilled oil. Servicing the Eccentric Oil Oil Type: Detergent oil (API service ...

DANGER In certain conditions, gasoline is extremely flammable and highly explosive. A fire or explosion from gasoline can burn you and others and can damage property. • Set the throttle to slow, stop the engine and keep heat, sparks, and flame away. • Handle fuel only outdoors. • Wipe up spills immediately. • Do not smoke while handling fuel. 1. Stop the engine and wait for all moving parts to stop. 2. Disconnect the wire ...

spark plug. Do not clean the electrodes because grit entering the cylinder can damage the engine. 5. Set the gap on the plug to 0.030 inch (0.76 mm) (Figure 24). Figure 24 1. Center electrode insulator 2. Side electrode 3. Air gap (not to scale) 6. Carefully install the spark plug by hand (to avoid cross threading) until it is hand tight. 7. Tighten the spark plug an additional 1/2 turn if it is new; otherwise ...

1. Fill the fuel tank with gasoline. 2. The spark plug is pitted, fouled, or the gap is incorrect. 2. Install a new, correctly gapped spark plug. The engine will not start, starts hard, or fails to keep running. 3. The air cleaner is dirty. 3. Clean or replace the air cleaner elements. 1. The oil level in the eccentric housing is too high. 1. Check the oil level and drain a ...

A limited warranty (see warranty periods below) Concrete, Masonry, and Compaction Equipment Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Concrete, Masonry, and Compaction Equipment Products listed below to be free from defects in materials or workmanship. This warranty covers the cost of parts and labor, but you must pay transpor ...