hager 3600 Series Manuals

3600 Series ANSI Grade 2 Tubular Lever Set Installation Instructions Meets ANSI 156.2 I-LS00769 For use on doors 1-3/8” to 1-3/4” (35 mm - 45 mm) thick REV 2 Page 1 of 2 2. MARK DOOR TOOLS REQUIRED FOR NEW INSTALLATION: (1) Phillips Head Screwdriver (1) 2-1/8” (54 mm) Hole Saw (1) 1” (25.4 mm) Drill Bit (1) Chisel TOOLS REQUIRED FOR REPLACEMENT INSTALLATION: (1) Phillips Head Screwdriver FOR REMODELING OR NEW CONSTRUCTION: -Follow all steps FOR REPLACEMENT OF EXISTING LOCK: -Follow steps 1, 3C, 4C, 5C, 6 through 9 after removal of old lock FOR CYLINDER REPLACEMENT: -Follow Step 10 Measure center line of lock; height as desired from finished floor. Select 2-3/8” or 2-3/4” backset, fold and apply template to high side of door bevel and mark center of door edge as indicated on template. Mark center hole on door face through guide on template. 3. DRILL HOLES Drill 2-1/8” (54 mm) hole through door face as marked for lockset. (It is recommended that holes be drilled from both sides on wood doors to prevent splitting.) Drill 1” (25.4 mm) hole in center of door edge for latch. 4. INSTALL LATCH A. Insert latch in hole keeping it parallel to face of door. Mark outline of latch face plate and remove latch. B. Chisel 5/32” (4 mm) deep or until latch face plate is flush with door edge. C. Insert latch and tighten screws. NOTE: Latchbolt bevel must face to closing direction. For doors with a 1-1/8” wide latch cutout, insert latch through optional spacer and then install latch in door. 1. LATCH BACKSET ADJUSTMENT A. If 2-3/4” backset is required, pull spindle cam all the way to the right edge of the adjusting hole. B Be sure spindle hole is properly aligned. It is important that the spindle hole remains properly aligned throughout the installation. C. The latch is now set for 2-3/4” backset. OUTSIDE ROSE ASSEMBLY OUTSIDE LEVER (REVERSIBLE) SPINDLE SCREW POST OUTSIDE FIRE SHIELD LATCH SCREWS ASA STRIKE FACE PLATE LATCH INSIDE FIRE SHIELD INSIDE MOUNTING ASSEMBLY MOUNTING SCREWS INSIDE ROSE TURN PIECE INSIDE LEVER (REVERSIBLE) (ILLUSTRATION: ENTRANCE FUNCTION) D. To reset the latch to 2-3/8” backset, push the spindle cam to the left edge of the adjusting hole. SPINDLE CAM RIGHT WRONG CENTER LINE MARK FOR 2-1/8” (54 mm) HOLE ON DOOR FACE MARK FOR 1” (25.4 mm) HOLE IN DOOR EDGE 2-1/8” (54 mm) HOLE FOR LOCKSET 1” (25.4 mm) HOLE FOR LATCH SPACER (OPTIONAL)