Heath Zenith CB-2010 Manuals

OPERATION Model CB-2010 Motion Sensor Light Control with Protective Lamp Shields © 2000 Heath Co. a div. of DESA International 598-1090-00 * resets to Auto Mode at dawn. TEST Light Control Sensor Cover Plate Lamp Holders 6 Screws (3 sizes included) Gasket Features • Turns on lighting when motion is detected. • Automatically turns lighting off. • Photocell keeps the lighting off during daylight hours. This package includes: Requirements • The Light Control requires 120-volts AC. • If you want to use the Manual Mode, the control must be wired through a switch. • Some codes require installation by a qualified electrician. • This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations. TEST 1 5 20 ON-TIME Put ON-TIME switch on the sensor bottom to TEST. MANUAL MODE ON-TIME TEST 1 5 20 ... back on. AUTO 1 Second OFF then... Put the ON-TIME switch in the 1, 5 or 20 minute position. Move ON-TIME Switch to 1, 5 or 20 minutes Mode Switching Summary Flip light switch off for one second then back on* MANUAL MODE AUTO TEST Note: When first turned on wait about 12 minutes for the circuitry to calibrate. Manual mode only works at night because daylight returns the sensor to AUTO. Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE. Manual mode works only with the ON-TIME switch in the 1, 5, or 20 position. * If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode. Mounting Bolt Mounting Strap Test 5 Sec x x Auto 1, 5, 20 min. x Manual Until Dawn* x Mode: On-Time: Works: Day Night Rubber Plug Plastic Hanger 2 PAR Lamps 2 Wire Connectors