HME TI6000 Manuals

TI6000 Telephone Interface INSTALLATION / OPERATING INSTRUCTIONS The TI6000 provides a link between a telephone and the Wireless IQ System. It allows its user to answer and speak on the telephone using a COM6000 COMMUNICATOR. The TI6000 can only be used with Wireless IQ Systems that were originally configured for single-lane operation. Figure 1. TI6000 with cables and telephone jack splitter 1. INSTALLATION Installation of the TI6000 will take approximately 1 hour. Before you begin, coordinate the time of installation with the store owner/manager to minimize disruption of business. The following tools are required:  Phillips (cross-point) screwdriver, size #2  Power drill and drill bit set  Wire cutter/stripper  Small standard (slotted) screwdriver 1.1 Wall Mounting The TI6000 must be mounted on the wall, not more than 2 ft (.61 meter) from the Wireless IQ Base Station, so the base station interface cable will reach between the two units. Mount the TI6000 as follows:  Hold the TI6000 against the wall at the desired location. Mark the wall through the screw hole in the flange on each side of the unit.  Set the unit aside and drill two 3/16 inch (4.8 mm) holes at the marked spots, deep enough to insert the enclosed screw anchors.  Insert the screw anchors completely into the two holes in the wall.  Hold the unit against the wall with the holes in its flanges over the anchors. Screw the two enclosed screws through the holes, all the way into the anchors. Figure 2. Mark wall through screw holes shown by arrows