Human Touch HT-270 Manuals

REMOVING THE BACKREST COVER 1. Use the remote control to raise the backrest to a fully upright position. 2. Power off the chair and unplug it. 3. Using a Phillips-head screwdriver, remove the two screws that secure the remote control bracket to the backrest cover (Fig.1). 4. Pull the remote control cables through the backrest cover, then disconnect the cables. 5. Using a 5/32" (4mm) " (4mm) " Allen key, remove the four backrest cover screws. (Fig.2). 6. Tip the backrest cover backward then lay it carefully on the floor behind the chair. 7. Disconnect the three connectors (Fig.3). 8. Remove the backrest cover. Tools Required: 5/32" (4mm) Allen key " (4mm) Allen key " , Phillips-head screwdriver (4mm) Allen key, Phillips-head screwdriver (4mm) Allen key NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY. REPLACING THE BACKREST COVER HT-270 06/01/08 (Fig.1) (Fig.2) (Fig.3) 1 To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions. SERVICE LEVEL: 2

GET READY REMOVING AN ARMREST 1. On the bottom of the chair near the front, locate the nut that secures the armrest to the chair frame, then loosen the nut as far as possible using a 16-mm wrench (Fig.2). 2. Pull up on the armrest to provide further access to the nut, then remove the nut. 3. Push the armrest toward the front of the chair until it disengages from the slot that secures it, then remove it from the chair base (Fig.3). 1. Press down on the electronic footrest lever on the right-hand side of the chair to fully retract the foot and calf massager. 2. Power off the chair and unplug it. 3. Using two people, turn the chair gently on its side, with the armrest you wish to replace on top (Fig.1). Armrest Nut X1103 Tools Required: 16-mm wrench, 2 people (to turn chair on its side) NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY. REPLACING AN ARMREST HT-270 06/01/08 (Fig.1) (Fig.2) (Fig.3) 1 To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions. SERVICE LEVEL: 2

ITA manuale di utilizzo & di manutenzione ENG FRA ESN use & care manual notice d’utilisation et d’entretien manual de uso y cuidado DEU Gebrauchs- und Pflegeanleitung ht 270 ©2007 Human Touch®, LLC. Patents Pending and intellectual property rights enforced. No medical claims are warranted or implied by the use of this product. Human touch is a trademark of Human Touch®, LLC. H T- 2 7 0 - 5 L - A 0 humantouch.com use & care manual

© Interactive Health®, 2006 Patents Pending and intellectual property rights enforced. No medical claims are warranted or implied by the use of this product. HT is a trademark and HTT Human Touch Technology is a registered trademark of Interactive Health®, Inc. w w w.vitalityweb . c o m H T- 2 7 0 - A 2 USE & CARE MANUAL HT™-270 ROBOTIC MASSAGE ® CHAIR