Human Touch HT-270 Quick Start Manual

1. Use the remote control to raise the backrest to a fully upright position. 2. Power off the chair and unplug it. 3. Using a Phillips-head screwdriver, remove the two screws that secure the remote control bracket to the backrest cover (Fig.1). 4. Pull the remote control cables through the backrest cover, then disconnect the cables. 5. Using a 5/32" (4mm) " (4mm) " Allen key, remove the four backrest cover screws. (Fig.2). 6. Tip the backrest cover backward then lay it carefully on the floor behind the chair. 7. Disconnect the three connectors (Fig.3). 8. Remove the backrest cover. Tools Required: 5/32" (4mm) Allen key " (4 ...

1. Place the new backrest cover on the floor behind the chair, as shown (Fig.4). 2. Connect the three sets of connectors. 3. Thread the remote control cables from the backrest through the backrest cover, so that they are accessible after the backrest cover is installed. 4. Place the backrest cover into position, aligning the four screw holes. 5. Using the 5/32" (4mm) " (4mm) " Allen key, replace the four backrest screws. NOTE: Be sure to use the two longer screws in the upper screw holes and the two shorter screws in the lower screw holes. 6. Reconnect the remote control cables, then push the cables into the backr ...