Icom IC-R30 Manuals

ADVANCED MANUAL COMMUNICATIONS RECEIVER iR30 11 SPECIFICATIONS 10 OPTIONS 9 UPDATING THE FIRMWARE 8 Bluetooth® OPERATION 7 OTHER FUNCTIONS 6 MENU SCREEN 5 GPS OPERATION 4 MEMORY OPERATION 3 RECORDING AND PLAYING BACK 2 microSD CARD 1 POWER SUPPLY INTRODUCTION

BASIC MANUAL COMMUNICATIONS RECEIVER iR30 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.

SERVICE MANUAL COMMUNICATIONS RECEIVER |R30 S-15501XZ-C1 June 2018

[email protected] WildlifeComputers.com +1 (425) 881-3048 8310 154th Ave NE, Suite 150 Redmond, WA, 98052 USA v.20-06 © Wildlife Computers. All rights reserved. QUICK START GUIDE—TAG INITIALIZATION ICOM IC-R30 RECEIVER SET-UP INSTRUCTIONS 1. Turn the receiver to “On” using the left-side power button. 2. Set the screen view to “Single View” and “A” band. a. Hold the [MAIN/DUAL] button down for one second to toggle between the single and dual channel views. b. Set to “Single View”—only displays a single frequency on the screen. Select “A” band by pressing the [MAIN/DUAL] button to display “A” band on the top left of the screen. 3. Set “Squelch” to “Open” using the button on the left side. a. Hold the “SQL” button down and rotate the top dial to [SQUELCH:OPEN], then release. 4. Adjust the volume using the buttons on the left side. 5. Set the receiver to “VFO” mode (do not set to “Memory” mode). a. Press the [VFO/MR] button to toggle between modes. “Incorrect Memory Mode” displays “MR” in the center of the screen. In the correct VFO mode, the VFO symbol is not displayed on the screen. 6. Set the tuning step to 0.1 kHz. a. Press the TS button and rotate the dial to 0.1 kHz, press “Enter.” 7. Tune to Argos frequency 401.679 MHz. a. Press the [F-INP] button to clear the screen and type in 401.679 on the keypad. b. Do not press ENTER—if the menu appears, the “CLEAR” button will clear it. 8. Set the mode. a. Press the [MODE] button and rotate the dial to “LSB,” press “Enter.” “LSB” will be displayed below the “A” band in the top left of the screen. 9. Start with “RF Gain” set to “Max.” a. Press the [QUICK] button to expose the drop-down menu. Rotate the dial to “RF Gain.” Press “Enter.” Rotate the dial to “RFG MAX.” Press “Enter.” 10. Start with the “Attenuator” set to “OFF.” a. Press the [QUICK] button to expose the drop-down menu. Rotate the dial to “ATT.” Press “Enter.” Rotate the dial to “OFF.” Press “Enter.” 11. Adjust the frequency to the desired tone. a. When tracking a tag, use the dial to tune the receiver above or below 401.679 MHz to your desired tone.