Inovelli NZW30 Manuals

Federal Communications Commission (FCC) Statement FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may caus harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. IC Caution: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. DECLARATION DE CONFORMITE D'INDUSTRIE CANADA Ce périphérique a été testé et reconnu conforme aux limites spécifiées dans RSS-210. Son utilisation est soumise aux deux conditions suivantes : (1) il ne doit pas provoquer d'interférences gênantes et (2) il doit tolérer les interférences re.ues, notamment cellessusceptibles d'en perturber le fonctionnement. WARRANTY NZW30 Smart Switch Manual smart switch WARRANTY Show Home Products warrants this product to be free from manufacturing defects for a period of two years from the original date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or incidental damage to other products that may be used with this product. This warranty is in lieu of all other warranties, expressed or implied. Some states do not allow limitations on how long an implied warranty lasts or permit the exclusion or limitation of incidental or consequential damage, so the above limitations may not apply to you. This warranty gives you specific rights, and you may also have other rights which vary from state to state. if the unit should prove defective within the warranty period. SPECIFICATIONS WARNING RISK OF FIRE Model:NZW30 RISK OF ELECTRICAL SHOCK Power: 120 VAC, 60 Hz. RISK OF BURNS Signal (Frequency): 908.42 MHZ. CONTROLLING APPLIANCES: Dimension(L*W*H):115*71*42(mm) EXERCISE EXTREME CAUTION WHEN USING Z-WAVE DEVICES TO CONTROL Maximum Loads: 600W, incandescent, APPLIANCES. OPERATION OF THE Z-WAVE DEVICE MAY BE IN A DIFFERENT ½ HP Motor or 1800W (15A) Resistive ROOM THAN THE CONTROLLED APPLIANCE, ALSO ANUNINTENTIONAL ACTIVATION Range: Up to 100 feet line of sight between the MAY OCCUR IF THE WRONG BUTTON ON THE REMOTE IS PRESSED. Z-WAVE DEVICES Wireless Controller and the closest Z-Wave MAY AUTOMATICALLY BE POWERED ON DUE TO TIMED EVENT PROGRAMMING. receiver module. DEPENDING UPON THE APPLIANCE, THESE UNATTENDED OR UNINTENTIONAL Operating Temperature Range: 32-104° F (0-40° C) OPERATIONS COULD POSSIBLY RESULT IN A HAZARDOUS CONDITION. FOR THESE For indoor use only. REASONS, WE RECOMMEND DO NOT RETURN THIS PRODUCT TO THE STORE Specifications subject to change without notice THE FOLLOWING: due to continuing product improvement DO NOT USE Z-WAVE DEVICES TO CONTROL ELECTRIC HEATERS OR ANY OTHER Website www.ishowlights.com APPLIANCES WHICH MAY PRESENT A HAZARDOUS CONDITION DUE TO UNATTENDED OR UNINTENTIONAL OR AUTOMATIC POWER ON CONTROL. 1. Getting To Know Your New Z-Wave Device Turn ON/OFF manually or remotely via the Z-Wave controller • Can be Included in multiple Groups and Scenes • Compatible with all incandescent and CFL/ LED bulbs • Blue LED indicates switch location in a dark room • Z-Wave Certified for simple pairing and integrated home automation • Screw Terminal Installation — requires wiring connections for Line (Hot), Load, Neutral. • Screw Terminal Installation — requires wiring connections for Line (Hot), Load, Neutral.