Johnson Controls P2000 Manuals

24-10707-15 Revision E December 2017 P2000 Security Management System CKM-EP1502 authentic Mercury™ controller hardware installation

P2000 Security Management System Version 3.10 and higher, June, 2010 24-10515-21 Revision – Enterprise Configuration

24-10707-112 Revision D December 2017 P2000 Security Management System CKM-CE75-E1M enclosure with power supply hardware installation

24-10707-82 Revision D December 2017 P2000 Security Management System CKM-MR16OUT authentic Mercury™ terminal module hardware installation

P2000 Security Management System Comark Server Hardware Installation Instructions 1 Refer to the QuickLIT Web site for the most up-to-date version of this document. Introduction This manual provides instructions for installing the P2000 Security Management System (SMS) server (product code P2K-311-UL). A typical P2000 system consists of a Comark server computer loaded with the required operating system, database server, prerequisites, and P2000 software. Additional system hardware and software are purchased separately. Qualification for Installation While these instructions are intended to guide you completely through the installation process, the technician installing these machines should possess a reasonable level of experience with server hardware and software, which should include networks and networking principles, network communication, cabling, and computer component installation. This level of experience is necessary to determine if steps are mistakenly omitted, completed incorrectly, or in situations where requirements of a particular site call for system configuration other than what is described in this manual. Technical Support Technical assistance is provided to Johnson Controls authorized dealer representatives from 5 a.m. PT to 5 p.m. PT Monday through Friday. System users can get answers to operator questions by calling the local Johnson Controls Inc. sales/service office. The authorized dealer representatives can also provide you with information on the maintenance contracts and the on-site field service. Package Contents and Warranty Information Inspect the shipping containers as soon as they are received. If any damage is observed, have the delivery agent note the damage on the shipping document. Some shippers may wish to be present when a damaged container is opened. Closely examine the equipment. If the equipment is damaged in any way, notify the carrier and a Johnson Controls® representative immediately. Check the purchase order against the equipment received to ensure that the order is complete. Retain all packaging materials for possible reshipment. Johnson Controls-labeled products are sold with a three year parts and shop labor warranty. Liability is limited to repair or replacement at the discretion of Johnson Controls, Inc. Hardware Installation This section describes how to install the Comark server. All boards and devices are factory installed. (Computer configuration may differ slightly, at the manufacturer’s discretion. Adjust any installation steps or settings, as necessary). To install the Comark server: 1. Unpack the equipment and check for damage. See Package Contents and Warranty Information on page 1. 2. If mounting the server in a rack, install the rails with the hardware provided. Then, mount the server in an appropriately sized mounting rack. See Figure 1 for dimensions. Figure 1: Dimensions and Front Panel Components 3. Connect the server to the LCD monitor using the VGA or DVI cable provided. See Figure 2 for component connections on the server. Figure 2: Server Rear Panel Components 4. Connect the LCD monitor power cable. See Line Power Requirements on page 2. 19 in (48 cm) 7 in (18 cm) 17.7 in (45 cm) Behind the Door: • 2 USB Ports • Reset Switch VGA Connector RJ-45 Connector (2) Key/MS Connector Parallel Port Connector USB Connector (2) Serial Connector (2) Audio Connector DVI Connector On/Off Switch Power Cord Connector Rear Panel P2000 Security Management System Comark Server Hardware Installation Instructions Part No. 24-10618-112, Rev. A Issued April 20, 2012

VPN/DSL Security Option Installation Manual P2000 Security Management System April, 2012 24-10618-155 Revision A

P2000 Security Management System Version 3.10 and higher, June, 2010 24-10515-13 Revision – DVR Integration