Kinetronics SV-4400U Manuals

Thank you for purchasing your new StaticVac® film cleaning machine. It will provide years of effective operation if three simple maintenance procedures are followed. Begin by connecting the cord from the transformer to the machine and plugging the machine into a GROUNDED (three wire) outlet. If an extension cord is necessary be sure to use a GROUNDED type. Failure to properly ground your machine may result in damage to the machine or other electronic equipment. Place the StaticVac as close as possible to the printer or projection gate for the best performance. You will find eight (8) small magnets located in the plastic bag Each magnet has foam adhesive tape for mounting to your printer. Use four (4) for mounting if printing front to back and four (4) for mounting if you are printing left to right or right to left. The on/off switch is located on top of the machine and when pressed “red” will show on the switch and the “green” LED indicator will light. The machine can be run continuously during normal operation and need not be turned off when not in use. STATICVAC FILM CLEANER MODEL SV-4400U TROUBLE CHECKS INSTRUCTION SHEET ENGLISH ENGLISH REMEMBER, TO ENSURE PROPER PERFORMANCE, CLEAN EMITTERS, BRUSHES AND FILTER REGULARLY. It will save time and money. If service should be necessary, call, write or fax Kinetronics Service Department. SYMPTOM: No power (green light won’t come on). REMEDY: Check to see if the unit is plugged into a properly grounded outlet. Check if on/off switch is on. Check connecting cord. SYMPTOM: Film does not pull easily through machine or “catches.” REMEDY: Check brush tension. Adjust the brushes by loosening the SS screws on each side of the brushes. Film should pass smoothly with a light tension. SYMPTOM: Film has “dust spots” remaining after cleaning. REMEDIES: a) With the machine unplugged, open the lid and check for accumulated dust in brushes. Vacuum thoroughly. Brushes may also be washed in mild shampoo and water. b) With the machine unplugged, open the lid, check to see that the emitter pins are free of dust. Clean with a cotton swab. c) Check the filter. If dirty, replace or clean. d) Check brush tension. (You may wish to remove and shampoo brushes with gentle baby shampoo, rinse carefully, comb brush hair straight and let AIR DRY.) SYMPTOM: Fan/blower stops or won’t run. REMEDY: With the machine unplugged, check that there are no obstacles caught in the fan. If your machine has some other problem or the above remedies don’t work, service help is available at 1-800-624-3204 (in U.S. and Canada) or 941-951-2432, FAX 941.955.5992, or contact your local Dealer or Distributor. Part No. 405.1E