Nuvico Xcel NCT-5ML-E2 Manuals

Package Overview Installation 1 2 3 4 ►Connecting Network Cable ①Loosen the nut from the main element. ②Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector. ③Connect the cable to the hermetic connector. Then tighten the nut and the main cover. Warning and Caution ■If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself. (We shall not be responsible for any problems caused by unauthorized repair or maintenance.) ■Do not allow water or liquid intrusion into the camera. ■In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region. When the product is mounted on wall or ceiling, the device shall be firmly fixed. ■Do not use camera beyond specified voltage range. ■Do not drop the camera or subject it to physical shock. ■Avoid touching the camera lens. ■If cleaning is necessary, please use clean cloth to wipe it gently. ■Do not aim the camera at the sun or extra bright place. ■Do not place the camera in extremely hot, cold (the operating temperature shall be -22˚F~140˚F), dusty or damp locations, and do not expose it to high electromagnetic radiation. ■To avoid heat accumulation, good ventilation is required for operating environment. NCT-5ML-E2 Eyeball Camera Quick Start Guide Camera Quick start guide CD Plastic plug ×3 Drill template Screwdriver Tapping screw × 3 ③ and then d the drill template. Attach the drill template to the place where you want to fix the camera rill the screw holes and the cable hole on the wall according to ■Please read these instructions carefully before operating the unit and keep it for further reference. ■All the examples and pictures used here are for reference only. ■The contents of this manual are subject to change without notice. * 2 If the PoE switch is used to power the camera that supports PoE power supply, DC12V power supply is not required. Security Cap 2 1 3 Network connector Power connector 1 2 3 4 5 6 Fixed screw Micro SD card slot* Reset* Mounting base Fixed Screw Mounting Base Enclosure Dome 1 2 3 4 DC12V Please make sure that the wall or ceiling is strong enough to withstand 3 times the weight of the camera. ① install the cover back to the dome and fix it firmly with the screws. Note that the cover should not be installed unevenly. (Please skip this step if your camera has no micro SD card slot). ② Loosen the fixed screw to disassemble the camera. Remove the cover from the dome to insert the SD card. Then, 5 6 Cover Note: Micro SD card slot and reset are optional. If no such interfaces, please skip the above-mentioned(5, 6) instructions. * 1 It is recommended to install the security cap for outdoor installation.