Overland Storage Spare Fan Manuals

10400416-001 11/2012 ©2012 Overland Storage, Inc. Page 1 of 4 *10400416-001* SnapServer™ DX2 / SnapScale™ X2 Node Spare Fan Instructions This document describes how to remove and replace a fan in a SnapServer DX2 appliance or SnapScale X2 node from Overland Storage. WARNING: To reduce the risk of electric shock or damage to equipment, always remove any power cords while working with the unit. AVERTISSEMENT: Pour réduire le risque de choc électrique ou endommagement de l'équipement, retirez toujours les cordons électriques en travaillant avec l'appareil. CAUTION: While working with the unit, observe standard Electrostatic Discharge (ESD) precautions to prevent damage to micro-circuitry or static-sensitive devices. NOTE: These instructions are for chassis with captive screws at the top of the side flanges. For units with the screws at the bottom of the side flanges, contact Overland Service. Prepare the Unit Power Off and Disconnect 1. Power off the unit/cluster: • SnapServer DX2: Press the Power button on the right flange to cleanly shutdown the unit. • SnapScale X2 Node: Use the Web Management Interface (Maintenance > Shutdown/Restart > Shutdown) to cleanly shutdown the cluster. 2. When all the front LEDs are off, disconnect the power cords of the unit being repaired. 3. Disconnect all the cables from the unit. Remove the Front Bezel Carefully take hold of the front bezel and pull it straight out from the appliance until the magnets release. Set it aside. Power Sockets Cable Ports SnapServer DX2