Philips Dynalite DDBC516FR Manuals

features To reduce the risk of fire or electric shock, do not expose this device to rain or moisture. Do not energise unless the front cover is in place. This device must be earthed. Installation, programming and maintenance must be carried out by qualified personnel.  Single Phase Supply - 1 phase at 0.15A  5 x Feed thru Outputs Rated at 16A  Power outputs are Latching Relays  Manual Overrides for each channel  Powerful Internal PLC - Custom scripts can be written to provide process control based on conditional logic  Dry Contact Interface - An Auxiliary dry contact interface is provided. The factory settings will cause this input to transmit network identification information  Many Control Options - Control of this device can be via a combination of methods, eg. serial control port, relay contacts, push button wall stations, infrared receivers and time clocks  Simple Installation - DIN Rail mount facilitates installation. All connection terminals are accessible without disassembly Warning – This device is a class A product. In a domestic environment this product may cause radio interference, in which case the user may be required to take adequate measures. Read Instructions – We recommend that you read this Instruction Manual prior to commencement of installation. Manual Override Switches - These switches do not provide permanent isolation. Isolate at the supply before performing work on load circuits. Special Programming – This device will only operate in basic modes unless programmed via a computer. If programming is required, contact your local agent for details. Once the data cable is connected to the devices, the factory default settings will allow any control panel to operate all channels in all controllers. Power Sources – This device should only be operated from the type of supply specified on the front cover. This device must be earthed. Feed Thru Output Circuits – The load on a circuit should not exceed the specified capacity of 16A. Loads should be calculated to ensure that the overall maximum capacity of 80A is not exceeded. This device should be fed via a HRC fuse or MCB. Output circuits are suitable for Single Phase or Three Phase Star (with Neutral) only, Delta wiring is not supported. Mounting Location – Install in a dry, well-ventilated location. Controllers may emit some mechanical noise. Take this into account when deciding the mounting location. Data Cable – Use screened, stranded RS485 data cable with three twisted pairs. Segregate from mains cables by 300mm minimum. Connect devices in a ‘daisy chain’. A data cable that is connected to an energised device is live. Do not cut or terminate live data cables. DDBC516FR 5 x 16A relay & Open Protocol Controller Installation Manual ……… electrical diagram