Philips PAN44 Manuals

Smart Energy Plug PAN44 This plug-in ON/OFF switch PAN44 is a devices displaying the Z-Wave PlusTM logo can also be used security enabled wireless switch, based on Z-Wave Plus technology. Z- Wave PlusTM enabled with it regardless of the manufacturer, and can also be used in other manufacturer’s Z-WaveTM enabled networks. Remote On/Off control of the con- nected load is possible with another manufacturer’s wireless Controller. Each switch is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. Because PAN44 supports Security Command Class, it can learn with Secured controller. Its functionality and supported command classes are identical when included as a secure and non-secure device. This plug-in ON/OFF switch is able to detect instance wattage (1560W/UL/TW/JP) and overload current (14.5A with resistive load) of connected lights or appliances. When de- tecting overload state, the Switch will be disabled and it’s On/Off button will be lockout of which LED will flash quickly. However, unplug and reconnect the switch will reset its overload condition to normal status. Specification Operating Voltage 100V-240V~ 50Hz~60Hz Maximum Load (Ampere) 13A (Resistive load) PAN44-1; PAN44-2 Range Minimum 40 m in door 100m outdoor line of sight Operating Temperature 0°C ~ 40°C Frequency Range 908.4MHz & 916.0MHz/ USA (PAN44-1); 920~927MHz/ Taiwan/ Japan (PAN44-2) RF Maximum Power +10dBm (Peak), -10dBm (Average) ** Specifications are subject to change and improvement without notice. Troubleshooting Symptom Cause of Failure Recommendation The Switch not working and LED off 1.The Switch is not plugged into the electrical outlet properly 2.The Switch break down 1. Check power connections 2. Don’t open up the Switch and send it for repair. The Switch LED illumi- nating, but cannot control the Switch of the load at- tached 1.Check if the load plugged into the Switch has its own ON/OFF switch 2. The switch is protected 1. Set the ON/OFF switch of the load attached to ON 2. Unprotected the switch or follow the instruction of pro- tection. The Switch LED illumi- nating, but the Detector cannot control the Switch 1. Not carry out association 2. Same frequency interference 1. Carry out association 2. Wait for a while to retry LED keep flashing, but cannot control Overload occurs Remove the load attached or check max. load cannot ex- ceed 13A (Resistive load)