-
Assembly & Parts Listing
1
-
Quick Learner Pre-Assembly Information
2
-
Quick Learner Features
3
-
Tools Needed to Assemble the “Quick Learner”
4
-
Hardware & Accessories
5
-
Fuel System Accessories
6
-
Other Optional Accessories
7
-
Section 1 – Upper Frame Assembly
9
-
Install (1) Clutch Bell Bearing Block to
10
-
Install both (2) Front Tail Transmission
11
-
Step 3 – Upper Frame Servo Installation
12
-
Install Rudder Servo in right upper
13
-
Section 2 – Lower Frame Assembly
14
-
Install (1) 54mm Cross-member using
15
-
Install (1) Rear Plastic Gyro Plate using
16
-
Section 3 –Drive-Train Assembly
17
-
Install (1) Main Shaft into Main Shaft
18
-
Adjust the Gear mesh between the
19
-
Install (1) Start Shaft into (1) Clutch
20
-
Install (1) Lower Fan Hub Collets on
22
-
Dial-indicate the Fan hub to ensure that
23
-
Install (2) Engine Mount Blocks to the
24
-
Step 1 – Landing Gear Installation
26
-
Install (2) Skid Pipes into the struts so
27
-
Build fuel tank cap with the following
28
-
Install receiver switch with the provided
29
-
Section 5 –Tail Installation
30
-
Step 1 – Tail Case Assembly
31
-
Install (1) 5 x 10 x 4 Flanged Bearing
32
-
Install (1) 5 x 10 x 4 Bearing into the
33
-
Step 2 – Tail Rotor Assembly
34
-
Attach (1) Double Bearing Tail Rotor
35
-
Step 3 – Installation of Boom
36
-
Rotate the Tail rotor down to a 90
37
-
Install the Boom Supports to Horizontal
38
-
Section 6 – Head, Swash-plate, & Washout Assembly
39
-
Step 1 – Swashplate Assembly & Installation
40
-
Install (1) Swashplate Anti-Rotation
41
-
Install Completed Washout Unit. Slide
42
-
Install (2) Hiller Arms to (2) Blade Grips
43
-
Install (1) Spindle through O-rings and
44
-
Install (1) Seasaw using (2) M3-8 Cap
45
-
Install (1) M3 Flybar using (2) M3-5-1
46
-
Section 7 – Linkage & Final Setup
47
-
Step 1A – Shim Ball Installation
48
-
Rear Upper Swash. Servo to Swashplate
49
-
Step 2- Rudder Push Rod Assembly
50
-
Step 6 – Final Building Information
53
