Response Electronics SAP E Manuals

These instructions cover basic set-up. For more advanced functions, please refer to your System Installation and Operating Manual. Introduction PIR Detectors are designed to detect movement in a protected area by detecting changes in infra-red radiation levels caused, for example, when a person moves within or across the devices field of vision. If movement is detected an alarm signal will be triggered, (if the system and alarm zone is armed). Note: PIR Detectors will also detect animals, so ensure that pets are not in areas fitted with PIR Detectors when the system is armed. Any number of PIR Detectors can be used with your system providing they are all coded with the system house code, and are mounted within effective radio range. The PIR Detector is powered by a PP3 alkaline battery. Under normal operating conditions this will provide an expected life in excess of 1 year. When the battery level becomes low the PIR Detector will flash a red LED behind the lens. When this occurs the battery should be replaced as soon as possible. Choosing a Position for the PIR Detector The recommended position for a PIR Detector is in the corner of a room mounted at a height of between 2 and 2.5m. At this height, the PIR Detector will have a maximum range of up to 12m with a field of view of 110°. The position of the PCB inside the PIR can be set to 5 different positions to adjust the range of the PIR Detector. Setting the PCB in position 3 will reduce the range to 9m approximately, with position 1 providing a range of 6m approximately. The recommended position setting for the PCB is in position 5. Note: The range as indicated above refers to the linear distance in front of the PIR Detector. When deciding upon the mounting position for the PIR Detector the following points should be considered to ensure trouble free operation: 1. Do not position the PIR Detector facing a window or where it is exposed to or facing direct sunlight. PIR Detectors are not suitable for use in conservatories or for external use. 2. Do not position the PIR Detector where it is exposed to draughts. 3. Do not position the PIR Detector directly above a heat source, (e.g. fire, radiator, boiler, etc). 4. Where possible, mount the PIR Detector in the corner of the room so that the logical path of an intruder would cut across the fan detection pattern. PIR Detectors respond more effectively to movement across the device than to movement directly towards it. 5. Do not locate the PIR Detector in a position where it is subject to excessive vibration. 6. Ensure that the position selected for the PIR Detector is within effective range of the System. Note: When the system is armed, pets should not be allowed into an area protected by a PIR Detector as their movement will trigger the PIR and generate an alarm. Note: DO NOT fix the PIR Detector to metalwork or locate the unit within 1m of metalwork (i.e. radiators, water pipes, etc) as this could affect the radio range of the device. 433MHz Wirefree Passive Infra-Red Movement Detector (SAP E) Installation and Operating Instructions 8 7 6 5 4 3 2 1 2 1 4 3 5 ECE ECE ON ON SW3 SW2 5 4 3 2 1 PCB Positions Indicator (positions 1-5) 5 4 3 2 1 Less Sensitive More Sensitive 110° 12 10 8 6 4 2 0 2 4 6 8 10 12 0 2 4 6 metres 10 8 12 0 2 metres Side View Top View