SECO-LARM ENFORCER 190 Manuals

OPERATING THE ENFORCER 190 / 190S MOUNTING THE DETECTOR It therefore should be mounted in a location within which every glass window and door to be protected is found. For greatest security, attach to the wall or ceiling, using screws instead of double-sided foam tape. For larger areas, two or more units can be used without fear of interfering with each other. SETTING THE SENSITIVITY The ENFORCER 190/190S includes SECO-LARM's unique patented Yellow turbulence LED. This LED flashes when environmental noise is high enough to cause false alarms, thereby allowing instant sensitivity setting without the use of a special external test meter. To set sensitivity, hold a thin flexible plastic ruler flat against a glass window within the unit's protection range. Pick up one end of the ruler while holding the other end down, and then let the ruler snap against the glass window. This should cause the Yellow LED to come ON, but the Red LED should not light. If the Red LED comes ON with a slight snap, the ENFORCER 190/190S may be too sensitive, and the sensitivity control should be turned counterclockwise with a small flat or phillips screwdriver. If the Yellow LED does not come ON, sensitivity should be increased by turning the control clockwise. Continue snapping the ruler on the window until the Yellow LED comes ON but the Red LED does not. Repeat this process with each window to ensure the ENFORCER 190/ 190S is set for every pane of glass. When the correct sensitivity is found using the above procedure, determine whether the sensitivity is high enough to trigger the alarm by snapping the ruler harder to simulate a break-in. If the Red LED does not come ON, the sensitivity must be increased. NOTE: For applications within this temperature range the sensitivity will be stable. If the temperature should drop below -14°F (-10°C), the sensitivity of the ENFORCER 190/190S will increase, and the sensitivity setting will need to be decreased. If the temperature should rise above 122°F (50°C), the sensitivity of the ENFORCER 190/190S will decrease, and the sensitivity setting will need to be increased. When setting sensitivity, make sure the room's environment is as close as possible to what it will be when the ENFORCER 190/190S is in use. For instance, if the curtains are usually closed at night when the alarm is armed, then set sensitivity with the curtains closed. If a window in the room is left opened, then set the sensitivity with window open. The sensitivity should always be retested when the environment of the room changes, such as when furniture is moved. Depending on the type of glass, sensitivity is different when set by tapping the inside or outside of the window with a ruler. For best results, tap the inside of the window. NOTE: DO NOT SET SENSITIVITY ANY HIGHER THAN NECESSARY TO PROTECT THE GLASS IN THE DETECTOR'S RANGE. SETTING SENSITIVITY HIGHER THAN NEEDED INCREASES THE CHANCE OF FALSE ALARMS WITHOUT INCREASING PROTECTION. LEAVING A DOOR OR WINDOW OPEN WILL ALSO INCREASE THE CHANCE OF FALSE ALARMS. TAMPER-PROOFING CASE For extra protection, the ENFORCER 190/190S is equipped with an N.C. Tamper Switch to protect against opening or breaking of the case. INSTALLATION SCREW TERMINALS: MIN MAX #7: N.C. TAMPER OUTPUT #6: COMMON TAMPER OUTPUT #5: COMMON GROUND #4: 12VDC #3: DRY RELAY N.O.* #2: DRY RELAY COMMON* #1: DRY RELAY N.C.* * For N.O. output, use Terminals 2 and 3 For N.C. output, use Terminals 2 and 1