Sonance BPS8 Manuals

Determine the location for the mounting platform. Ensure there is adequate room for the BPS8 Subwoofer at the location of the platform. The speaker opening must be located 12” (305mm) from the BPS8 Subwoofer to allow the port tube to reach through the platform. Place the mounting template on the side of the joist and drill six 1/2” (12.7mm) holes through the joist at the locations shown on the mounting template. 1 3 Hold the side of the BPS8 Subwoofer with the rubber damping pad up against the side of the joist and install the six lag screws and washers to secure the BPS8 Subwoofer in place. 4 12” (305mm) BPS8 Port Tube Architectural Series mounting platform On the end of the BPS8 port tube there is a tether. The tether will be used later to guide the BPS8 port tube through the mounting platform opening. 6 Tether Foam Position end of port tube as close as possible to back of mounting platform. Loop tether into the anchored zip tie and secure. This process ensures that bandpass connector is easily attached later and other tradespersons won’t infringe on port tube assembly area. 7 8 Tether into zip tie (1) Quickstart guide (1) Bandpass Subwoofer w/ port tube (1) Cardboard mounting template Mounting screws & washers: (6) 5/16” x 2” lag screws (for thinner beams) (6) 5/16” x 3” lag screws (for thicker beams) (6) 5/16” washers Box Contents Bandpass Subwoofer can be installed in joists spaced 16” on center or greater. BANDPASS STEREO SUBWOOFER QUICKSTART GUIDE BPS8 FOR USE WITH ARCHITECTURAL SERIES ® BANDPASS CONNECTORS Secure the wire to the zip tie to prevent accidental removal. Attach the four conductor wires to the input terminals. Positive wires to red terminals and negative wires to black terminals. Run a signal test using a 9V battery. NOTE: Port tube contains foam plug with tether, make sure pressure levels don’t expel the foam and tether. For wiring diagrams and detailed eManuals visit http://www.sonance.com/in-wall-in-ceiling/ architectural-series/medium-speaker-subwoofer If it is not possible to locate the BPS8 Subwoofer 12” away from the bandpass connector, the extra hose material (up to 8”) must be removed. While it is ok to shorten the hose, never extend the hose length. 2 BPS8 BPS8 GOOD BAD Included zip tie for wire Attach the mounting platform to the joists. For mounting platform installation details visit http://www.sonance.com/in-wall-in-ceiling/ architectural-series/medium-speaker- subwoofer. 5