Sub-Zero 400-2 Series Manuals

Installation Information Wine Storage Wine Storage (400- (400-22)) Series Series 2-2 #3758410 - Revision C - May, 2014 Anti-Tip Components Installation (424-2) If anti-tip bracket needs to be installed, follow these steps (See Figure 2-1): 1. Locate and mark two wall studs at back of unit installation location. 2. Identify and mark proper height to clear unit top. Space between unit top and bottom of bracket must NOT be more then 1/4" (6.1 mm) 3. Secure bracket to wall studs, located in step 1, mak- ing sure screws extend 7/8" (22.2 mm) into each wall stud. The bracket must extend a minimum of 3" (76.2 mm) over unit. 4. Refer to Installation Guide provided with unit for any additional information needed. Anti-Tip Components Installation (424FS-2, 427-2, 427R-2) If anti-tip bracket needs to be installed, follow these steps (See Figure 2-2): 1. Center anti-tip bracket at back of unit installation location. 2. Secure bracket to wall studs or flooring, making sure screws extend 7/8" (22.2 mm) into each wall stud or flooring. 3. Refer to Installation Guide provided with unit for any additional information needed. INSTALLATION CONSIDERATIONS This section covers common installation issues seen by Service Technicians. Improper installation, though not a valid service issue, has the potential to lead to a call for service. Installation related complaints could include, but are not limited to: Unit leveling, unit movement, door misalignment, improper door and drawer sealing, internal frost or condensation, exterior condensation, warm compartment temperatures, etc. NOTE: If additional installation information is needed, refer to the complete Installation Guide, or contact Sub-Zero Service Department. UNIT COULD TIP UNDER CERTAIN LOAD CONDITIONS. FAILURE TO INSTALL ANTI-TIP COMPONENTS AND EXTEND FRONT LEVELERS TO FLOOR ACCORDING TO INSTALLATION MANUAL CAN RESULT IN SERIOUS INJURY OR DEATH. Figure 2-1. Anti-Tip Components Wall Stud Bracket Figure 2-2. Anti-Tip Components Bracket

400 / 400-2 / 600 / 600-2 / 700 / 700-2 / 700-3 SERIES, MODEL 648PRO, ICB648PRO and UC SERIES CONDENSED ELECTRONIC CONTROL INFORMATION BOOKLET NOTE: If more detailed information on the electronic controls is needed, the appropriate Service Manual must be referenced. Part #3756590 - Rev. G - April, 2007