Sunpak S34?TSR Manuals

Infrared Dynamics, Inc © Copyright 2012 Form No 60043 – 5/12 Printed in USA Sunpak  S34‐TSR Outdoor Gas Infrared Patio Heater Installation, Operation and & Maintenance Instructions Installer: Please take the time to read and understand these instructions prior to installation. Installer must provide a copy of this manual to the owner. Owner: Keep this manual in a safe place in order to provide your service technician with the necessary information. For Assistance Call Toll Free (888) 317‐5255 Infrared Dynamics, Inc 3830 Prospect Avenue Yorba Linda, CA 92886 http:\\sunpak.us My Business 2012\Sunpak TSR\New Instructions.doc

P/N 65134-4/11 Sunpak Infrared Heater -Two Stage Remote- Operating, Programming, and Gas Type Conversion Instructions for Model S34 TSR These instructions are designed to be used in conjunction with Sunpak Installation, Operation & Maintenance Manual (P/N 65132). Should you have any questions regarding these instructions or need a copy of the Sunpak Manual, please contact the factory. Infrared Dynamics, Inc 3830 Prospect Avenue Yorba Linda, CA 92886 Tel: (888) 317-5255 www. Infradyne.com

Sunpak® S34-TSR Infrared Heaters 3 Basic Heater Operation Sunpak S34 TSR is an outdoor gas-fired infrared heater which is operated with a wireless remote control. The heater can be operated at a High setting with an input of 34,000 BTU/Hr or at a LOW setting of 25,000 BTU/Hr. Each heater comes with wireless operating remote controls that are pre-programmed for that heater. The number located on the louvered end of the heater corresponds to the number on the remote control. Should the original remote control become lost, additional remote controls can be purchased. However, the heater will need to be re- programmed for the new remote control. The Sunpak S34-TSR should always be started up and operated on the HIGH mode for the first 5 minutes to allow the heater to warm up. Starting up the heater on the LOW mode before the heater is warmed up may cause the heater to shut down prematurely. To correct this situation press the OFF button followed by the ON button and the HI button. Always PRESS the button for at least 1 second to allow proper transmission of the remote signal. Device Battery Wall Remote 2032 Button Type Handheld 21/23 – 12V Sunpak heaters have a spark ignition and electronic flame safety control. The pilot is only ON while the heater is operating. If the flame safety sensor fails to sense flame at the pilot, the heater will shut down and lockout. This may happen due to low gas pressure or a gusty wind. Should the heater lockout you may be able to hear a faint beeping from the heater control. To restart the heater, first press the OFF button before restarting the heater. Although these heaters are designed for outdoor installation and use, it is important that the wireless remote control(s) be protected from the weather. Should the remote control become wet, it may be necessary to replace the control. Keep controls out of reach of children Each control has four buttons (ON OFF HI LOW). The remote controls are powered by batteries. The remote control has an approximate 25 foot line of sight range. Weak batteries can limit the effective range of operation.