sunsei SE-1500 Manuals

SOLARCHARGER SE-1500 register your warranty on line – www.sunsei.com IMPORTANT! Please read the instructions before operating. • When working around batteries and other electrical equipment, please observe industry standard and manufacturer’s safety procedures. • Make connections in a well-ventilated area free from flammable gases or vapors. • For 12V systems, ALL connections should be in PARALLEL: Positive (+) to Positive (+), Negative (-) to Negative (-). • DO NOT attempt to recharge NON-RECHARGEABLE batteries. • Always CONNECT the charge controller to the battery FIRST. • When disconnecting your solar panel DISCONNECT the battery LAST. Components in the package Two (2) wire twist connectors Stainless mounting screws (4) Extension power cable (10ft.) Battery clamp wire (1.5ft.) O-ring connector wire (1.5ft.) Female 12V socket cable (1.5ft.) Male CLA adapter cable (1.5ft.) Panel-to-panel jumper cable (1ft.) 1- Test Press the sun-shaped button. The LED will light up when the panel receives sufficient daylight to produce power. 2- Mounting Press the sun-shaped button. The LED will light up when the panel receives sufficient daylight to produce power. 3- Battery Connection Position the solar panel where you would like it to be permanently installed. Angle the panel in such a way that it will be perpendicular to the strong midday sun (straight up in most cases), between 10 a.m. and 2 p.m. Insert each mounting screw and tighten carefully. Do not over-tighten. 4- Optional Multi-panel Note: Remove the connector caps before connecting the cables. First, connect the GREY plug of the 10-foot extension cable to the connector of the solar panel. Connect the cable of your choice to the battery. (see FIG. 4). Finally, connect the other end of this cable with the BLACK plug of the extension cable. SE 135/150/400/500/1200/1500 E SOLAR CHARGER WARRANTY Please register online at: www.sunsei.com ICP Solar Technologies grants the original purchaser of the Sunsei™ SolarCharger SE135/SE150/SE400/SE500/SE1200/SE1500 a 10-year warranty on the power output and a 2-year warranty on the materials of the module. ICP guarantees that the unit will produce a minimum 80% of its original minimum power rating for the Warranty Period from the original purchase date and to the original purchaser. ICP warrants the module to be free from defects in materials and workmanship under normal applications, installation, use and service conditions for the Warranty Period from the purchase date. Please note that ICP will not accept returns without prior authorization. The original proof of purchase is required for warranty validation. Warranty for accessories: A 2-year warranty is given on accessories such as, but not limited to, cables included with the product. The warranty applies from the original purchase date and to original purchaser only. For full warranty details, please consult www.sunsei.com Warranty coverage does not apply when: • A defect in a component which is not part of the original ICP module. • Damages caused by installation procedures that do not significantly conform to accepted industry standards. • Defect/damages caused by any misuse, abuse, subjected to improper voltage or power surge or abnormal environmental conditions (such as acid rain, other pollution, lighting, storm earthquake, fire etc), negligence or accident and Acts of God. • External corrosion, mold discoloration or the like occurs. • Damage caused by water infiltration unless the product is weatherproofed by ICP. • Damage to persons or property caused by improper installation, misuse or improper handling of this product. • Product bought from E-bay, liquidators, auction sales and other type of non-ICP authorized dealers. • Product serial tags or manufacturer seals have been removed, altered or tampered with. Unless otherwise agreed in writing by ICP, it is understood that the above are the only warranties given by ICP who neither assumes nor authorizes anyone else to assume for it any other obligations or liabilities in connection with the module. Some states do not allow exclusion or limitation of accidental or consequential losses so the exclusions may not apply to the purchase. This warranty gives you specific legal rights and you may have other rights, which vary from one state (or province) to another. WARRANTY SERVICE Where to Obtain Service After 30 days of purchase, warranty service is available at ICP Solar. ICP toll free 1-888- 427-7652 or email [email protected] to obtain a Return Merchandise Authorization (RMA) Number and shipping instructions. Proof of Purchase is required. The issuance of an RMA number does not imply acceptance of a warranty claim. Warranty claims are accepted after a thorough inspection and testing of your returned unit at out testing facility. If the returned unit is not found to be defective (No Fault Found), or other issues render the warranty void, the unit will be returned to you at your expense plus a handling charge of $50.00 CAD/US. Missing components will be assessed associated fees. What to do to Obtain Service Ship prepaid or carry in your product to ICP testing center. Be sure to have Proof of Purchase available and quote RMA number. If you ship the product, be sure it is insured and packaged securely. ICP is not responsible for he costs of deinstallation or reinstallation. Return product will not be accepted and processed without RMA number and/or freight collect.