TELEVAC MX200 Manuals

© 2017 The Fredericks Company | www.frederickscompany.com | [email protected] | +1 215 947 2500 televac_an3018 rev - Page 1 of 12 Televac Application Note 3018 MX200 EthernetIP Vacuum Controller Setup and Troubleshooting Guide for EthernetIP Option 2 Contents 1 Description....................................................................................................................................................... 1 2 Windows™ 7 Operating Systems Configuration ................................................................................................ 2 3 Windows™ 10 Operating Systems Configuration .............................................................................................. 7 4 Contact Us ..................................................................................................................................................... 12 1 Description This document explains the process for the setup, configuration, and troubleshooting of a Televac EthernetIP device. In order to communicate with the unit, the EthernetIP device’s IP address will need to be configured to the same network as the PLC. The following steps describe how to establish the initial connection, and what steps to follow should any issues arise. The second setup option assumes no internet connectivity and explains how to reconfigure the IP address of the local computer to match the module, which can then be connected to in order to adjust the settings to the appropriate configuration. If an internet connection is available, refer to the Setup and Troubleshooting Guide for Televac EthernetIP Option 1 (televac_an3017). Please see the EthernetIP for MX200 User Manual for a full description on Class 1 and Class 3 connections, and a complete ADI table including data instance, name, array length, access, and description. Please see Application Note 3016 for downloading an Electronic Data Sheet (EDS) file to a PLC.