TMP On-Stage Stands WS7500 Manuals

BEFORE YOU BEGIN: Remove all contents from the boxes. Assemble the Metal Structure (Figure A) 1. Locate the two holes on the upper horizontal tube. on the left Z-shaped leg (A). Install one support bar (C) in the upper two holes using two 1.5” Allen head bolts (J) and two Locking Nuts (K). 2. Install the second support bar (C) in the two holes located on the left vertical Z-shaped leg (A). 3. Locate the two holes on the upper horizontal tube. on the right Z-shaped leg (Part B). Install one support bar (C) in the upper two holes using two 1.5” Allen head bolts (J) and two Locking Nuts (K). 4. Install the second support bar (C) in the two holes located on the right vertical Z-shaped leg (A). 5. Locate the four holes on the bottom of the Legs (A & B). Insert the Feet (O) into the holes and tighten. Adjust stand to desired height. Be sure the stand is placed right side up and it’s rubber feet are firmly on the ground before proceeding with the next step. Assemble the Upper Work Surface 5. Align the holes in the Upper work surface (D) with the holes in the metal tabs on the Z-shaped legs (A&B) (see Figure B). This work surface has two mounting positions: The rear holes allow the stand to be flush with wall, and the forward holes allow for more space on the main work surface. 6. Take 4 Wood Screws (N) and attach the Upper work surface to the Z-shaped legs (A&B). Do not over-tighten. Assemble the Main Work Surface and Keyboard Tray 7. Take both side boards (I), top board (G) and bottom board (H), and fasten together with Allen head bolts (L) using the center holes (see Figure C). 8. Align keyboard tray (F) drawer slide with the drawer slides on the side boards (I) and insert the keyboard tray. 9. Take the main work surface (E) and place it on the floor bottom side up (see Figure D). 10. Align the holes in the top board (G) with the four inserts on the main work surface (E). 11. Take four 1.38” Allen head bolts (M) and attach the keyboard assembly to the main work surface. 12. Place the Main work surface (E) with attached Keyboard tray Assembly on the metal tabs on the Z-shaped legs (A&B). Align the holes in the work surface with the holes in the metal tabs (see Figure E). 13. Take 4 Wood Screws (J) and attach the Main work surface (E) to the Z-shaped legs (A&B). IMPORTANT: BEFORE USING YOUR STAND, BE SURE THAT ALL BOLTS AND NUTS ARE FULLY TIGHTENED. If desired, the height can be adjusted by spinning the small rubber feet clockwise to lower the height or counter clockwise to raise the height. Place a level on the main work surface to be sure the Workstation is level before placing any equipment on the workstation. ASSEMBLY INSTRUCTIONS WS7500 Figure A Figure B Figure D Figure E Figure C