Toro 38614 Manuals

Form No. 3365-702 Rev A Power Max® Snowthrowers Model No. 38614—Serial No. 311000001 and Up Model No. 38624—Serial No. 311000001 and Up Model No. 38624W—Serial No. 311000001 and Up Model No. 38634—Serial No. 311000001 and Up Model No. 38644—Serial No. 311000001 and Up Model No. 38654—Serial No. 311000001 and Up Operator's Manual Introduction This machine is intended to be used by residential homeowners or professional, hired operators. It is designed for removing snow from paved surfaces, such as driveways and sidewalks, and other surfaces for traffic on residential or commercial properties. It is not designed for removing materials other than snow, nor is a model with a pivoting scraper designed for clearing off gravel surfaces. Read this information carefully to learn how to operate and maintain your machine properly and to avoid injury and machine damage. You are responsible for operating the machine properly and safely. You may contact Toro directly at www.Toro.com for machine and accessory information, help finding a dealer, or to register your machine. Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your machine ready. Figure 1 identifies the location of the model and serial numbers on the machine. Write the numbers in the space provided. Figure 1 1. Model and serial number location Model No. Serial No. This manual identifies potential hazards and has safety messages identified by the safety alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions. Figure 2 1. Safety alert symbol This manual uses 2 words to highlight information. Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. WARNING CALIFORNIA Proposition 65 Warning The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. This spark ignition system complies with Canadian ICES-002. The enclosed Engine Owner’s Manual is supplied for information regarding the US Environmental Protection Agency (EPA) and the California Emission Control Regulation of emission systems, maintenance, and warranty. Replacements may be ordered through the engine manufacturer. © 2010—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN) Printed in the USA All Rights Reserved

Form No. 3366-129 Rev B PowerMax® Snowthrower Model No. 38614 Setup Instructions Setup Important: Refer to your Operator’s Manual for safety, maintenance, and warranty information. 1. Position the upper handle over the lower handle. Note: Do not remove the rubber band until you have installed the handle. Important: Route the 2 cables attached to the Quick Stick inside the upper handle legs (Figure 1). Do not pinch the cables. Figure 1 1. Cables 2. Secure the upper handle (Figure 1). 3. Remove the hairpin cotter and washer from the end of the speed control rod and insert the end into the lower link arm (Figure 2). Figure 2 4. Secure the rod end with the washer and hairpin cotter. 5. Remove the hairpin cotter and the outer washer from the trunnion on the upper end of the speed control rod (Figure 3). Figure 3 1. Speed selector lever 3. Inner washer 2. Trunnion 4. Outer washer Note: Do not remove the inner washer (Figure 3). 6. Shift the speed selector lever into Position R2. 7. Rotate the lower link arm up (Figure 4). Figure 4 8. Lift up the speed control rod and insert the trunnion in the hole in the speed selector lever located under the control panel (Figure 3). Note: If the trunnion does not fit into the hole when you lift up the speed control rod, rotate the trunnion up or down on the speed control rod until it fits. 9. Secure the trunnion and upper end of the speed control rod with the outer washer and a hairpin cotter. © 2011—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN) Printed in the USA All Rights Reserved