VENOM V540 Manuals

1/16th Hex Screws Motor Housing Timing Plate Sensor Port Bearings Output Shaft and Magnet Housing Sleeve Bottom Plate COUNTERCLOCKWISE / CLOCKWISE 1/16th Hex Screws TIMING The timing on the Venom™ V540 brushless motor is extremely easy to adjust. You will need to loosen the three 1/16th hex screws that are located at the top of the motor near the Sensor Cable Port. Grip the top and turn clockwise to advance the timing. (This adjustment applies when output shaft is set to turn counter clock- wise). The opposite is true to delay/retard timing. The rotation direction of the motor can be changed by switching any two of the three power wires. The effect of advancing the timing is to make slightly more power from the motor. The down side is increased heat and less run time. There is a balance to be found in adjusting the timing this is just one more tool in finding the balance for your set up. Note: if the motor is run in a counter clockwise direction the timing advance will be clockwise. Disassembling the Motor: 1) Remove all three Hex screws at the bottom of the motor with a 1/16th hex screw driver. 2) Remove the bottom plate from the Motor Housing. Remove or oil the bearing located in the plate where the out-put shaft has been removed. 3) Carefully remove the Output Shaft and Magnet. 4) Remove three smaller hex screws from the top of the Timing Plate. 5) Remove Sensor Port buy turning it clockwise and lifting out of the Motor Housing hole. 6) Located inside the Sensor Port slot inside the Motor Housing is the 2nd bearing to be oiled or removed. DISASSEMBLED NOTE: This is the manufacturer default setting • Never leave the motor unattended while it is ON or plugged in. If the motor overheats there is the potential for fire. • Always check the connections of the wires and cables to ensure correct polarity. • Make sure all wires and cables are well insulated to avoid short circuiting. • Avoid contact with water and any other liquids. If this occurs, stop the use of the product and set out to dry. • Never solder on the PCB or other components. • DO NOT over tighten the hex screws, this may lead to stripping them. Warranty does not cover the screws. • Check to make sure you have the correct gear ratio and never overload the motor. • DO NOT APPLY FULL THROTTLE if the motor has not been installed. The high RPM of these motor can possibly damage them. • Make sure all connections and screws have been fastened to avoid an out of control model. • Always use a high power soldering unit and avoid prolonged soldering to avoid damage to the different components of the motor. INSTALLATION Thank you for purchasing the Venom™ V540 Brushless Motor. This motor was designed for power and performance thanks to it’s well ventilated can and sensor capabilities. This Motor has bearings that are serviceable and a replaceable rotor. Sensor Cable VEN-1356 (Sold Separately): A Bi-Directional Sensor Cable must be used with the V540 Motor at all times or else the motor will not work. Plug the Sensor Cable into the Motor Sensor Cable Port and also into the desired ESC (Speed control). (Refer to PART KEY Drawing below) Power Wires: To connect the correct power wires that will provide power to the Venom™ V540, they will need to be soldered accordingly. (Refer to PART KEY Drawing below) 1) Install the V540 into the model 2) Connect the Sensor Cable to both the Venom™ V540 Motor and the desired ESC. 3) Connect the Orange, Yellow, Blue Power Wires to the ESC. NOTE: Check for correct polarity to avoid damaging the Motor and the ESC. 4) Make sure all connections are correct before running the model. PART KEY WARNING Soldiering Tabs Output Shaft VEN-1356 Sensor Cable Orange Sensor Cable Port Yellow ESC Speed Control Blue TOP BOTTOM (Sold Separately) all-guides.co m