VT Miltope nMAP2 Manuals

1 3800 Richardson Road South • Hope Hull, AL 36043 Tel: 334-284-8665 • Fax: 334-613-6302 http://www.miltope.com nMAP2 Wireless Access Point Quick Start Guide M365-780, 5 January 2015 The nMAP2 Wireless Access Point is a wireless communication device designed for use in the airborne environment. The nMAP2 wireless access point is not used in ground-based locations such as a home or office. The nMAP2 Wireless Access Point must be installed by personnel qualified and authorized to install equipment aboard aircraft. This quick start guide introduces the 802.11n/ac Multifunction Access Point, 2nd Generation (nMAP2) part number 903920-1 and provides basic setup information for use as a stand-alone access point using nMAP2 Wireless Access Point Operating Software part number 999239. After following the directions provided in this quick start guide, see nMAP2 Wireless Access Point Operating Software Operator’s Manual M365-768, available from VT Miltope, for detailed instructions to configure the operating software for your application. INPUT POWER/DISCRETE CONNECTOR J1 (RED) LAN PORT 2 CONNECTOR J2 (BLUE) 1408041A MOUNTING HOLES (6 PLACES) SPECIFICATIONS INPUT POWER 97 -134 VAC, 360 - 800 Hz OR 18 - 32 VDC, 28 W MAXIMUM -15°C to +70°C OPERATING HUMIDITY 5% TO 95% RELATIVE HUMIDITY, NON-CONDENSING OPERATING ALTITUDE ATMOSPHERIC PRESSURE EQUIVALENT TO -15,000 TO +15,000 FEET LAN PORTS 1 AND 3 CONNECTOR J3 (GREEN) 8-32 THREADED GROUND POINT 0.28 INCH MAXIMUM SCREW DEPTH LAN1 ACTIVE INDICATOR LAN2 ACTIVE INDICATOR LAN3 ACTIVE INDICATOR POWER INDICATOR RF ENABLE INDICATOR WLAN1 ACTIVE INDICATOR WLAN2 ACTIVE INDICATOR HARDWARE OVERVIEW