3Com Wireless LAN Switch WX1200 Quick Start Manual

Published November 2004 WIRELESS LAN SWITCH AND CONTROLLER QUICK START GUIDE This document describes how to do the following: ■Use the quickstart command to perform basic system configuration of a Wireless LAN switch (WX) running Mobility System Software Version 3.0. ■Configure a Mobility Domain for roaming. ■Open the ...

■EAP (802.1X) key pair and self-signed certificate (generated if you type usernames and passwords for users of encrypted SSIDs) ■Web AAA key pair and self-signed certificate (gen- erated if you type usernames and passwords for users of unencrypted SSIDs) The command automatically places all ports tha ...

for mynetwork.com is learned through DHCP. The WX relays information about WX switches in the network that contain a Distributed MAP configura- tion specific to that Distributed MAP. Preparing Clients MSS uses 802.1X for access to secure (encrypted) SSIDs. For a client to access an encrypted SSID ...

18 Click OK to close the Network Connection dialog box. Using the quickstart Command This example configures the following parameters: ■System name: WX1200-Corp ■Country code (regulatory domain): US ■System IP address: 10.10.10.4, on IP interface 10.10.10.4 255.255.255.0 The quickstart script asks ...

5 Figure 1 Single-Switch Deployment To run the quickstart command: 1 Attach a PC to the WX switch’s serial console port. (Use these modem settings: 9600 bps, 8 bits, 1 stop, no parity, hardware flow control disabled.) 2 Press Enter three times, to display a username prompt (Username:), a password prompt (Password:), and then ...

Another question the script asks is, “Do you wish to configure wireless?” If you answer y, the script goes on to ask you for SSID and user information, for unencrypted and encrypted SSIDs. If you answer n, the script generates key pairs for SSH and the admin- istrative users you entered, generates a ...

7 success: created keypair for admin success: created self-signed certificate for admin success: created keypair for eap success: created self-signed certificate for eap success: created keypair for webaaa success: created self-signed certificate for webaaa success: remember to save this config WX1200# save config 6 Optionally, e ...

Configuring a Mobility Domain for Roaming This procedure configures multiple WX switches to form a Mobility Domain. A Mobility Domain allows users to seamlessly roam from one WX switch to another. A Mobility Domain uses one seed switch. The other switches are members. Add the switches to the same VLAN. U ...

9 WX1200-Corp# save config Configuring a Member 1 Use the quickstart command to configure basic system parameters on a second switch (WX1200-Corp2). 2 Configure WX1200-Corp2 as a member of the Mobil- ity Domain. WX1200-Corp2# set mobility-domain mode member seed-ip 10.10.10.4 3 Verify and save the configuration cha ...