NETGEAR XS728T ProSAFE Software Administration Manual

San Jose, CA 95134 USA July 2015 202-11492-01 XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch Software Administration Manual ...

After installing your device, locate the serial number on the label of your product and use it to register your product at https://my.netgear.com. You must register your product before you can use NETGEAR telephone support. NETGEAR recommends registering your product through the NETGEAR websi ...

Connect the Switch to the Network. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Discover a Switch in a Network with a DHCP Server . . . . . . . . . . . . . . . . . . . . . . 5 Swit ...

Chapter 6 Security Management Security Settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 114 Access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 121 Port Authentication. . . . . . . . . . . . . . ...

This manual describes how to configure and operate the XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch by using the web-based graphical user interface (GUI). This manual describes the software configuration procedures and explains the options available within those procedures. These switches are referred to as the NETGEAR switch t ...

Switch Management Interface The NETGEAR switch contains an embedded web server and management software for managing and monitoring switch functions. The switch functions as a simple switch without the management software. However, you can use the management software to configure more advanc ...

Discover a Switch in a Network with a DHCP Server This section describes how to set up your switch in a network that has a DHCP server. The DHCP client on the switch is enabled by default. When you connect it to your network, the DHCP server automatically assigns an IP address to your swit ...

The screen expands to display more fields at the bottom of the screen. 7. Select the Disabled radio button to disable DHCP. 8. Enter the static switch IP address, gateway IP address, and subnet mask for the switch and type your password. Tip: You must enter the current password every time y ...

WARNING: When you change the IP address of your administrative system, connection to the rest of the network is lost. Be sure to write down your current network address settings before you change them.  To modify the network settings on your administrative system: 1. On your computer, a ...

Access the Management Interface from the Web To access the switch management interface, use one of the following methods: • From the Smart Control Center, select the switch and click Web Browser Access. For more information, see the documentation for this application at http://docs.netgea ...