Candy GOC 970AT Instruction Book

Text of Candy GOC 970AT Instruction Book

Heat Pump Tumble Dryer

Italiano English 2 14 Norsk Suomi Deutsch Italiano Svenska 38 26 50 74 62 Norsk Suomi Deutsch Français Italiano Svenska 14 38 26 50 74 62 Dansk 86

Unpacking the Product

Safety Reminders Use Installation The Laundry Environmental Issues Gias Service Installation Electrical Requirements Adjusting the Feet Ventilation Preparing the Load Clothes Preparation Do Not Tumble Dry Energy Saving Sorting the Load Controls and Indicators Selecting the Programme Door and Filter Opening the Door Filter Filter Care Indicator To Clean the Condenser Filter Water Container To Remo

Please check that the following items are

delivered with the appliance: ● Instruction manual ● Guarantee card ● Energy label Remove the machine from its packaging close to the final location of the machine. 1- Cut carefully around the base of the packaging and up one corner. 2- Remove the polythene sleeve and lift the dryer off the polystyrene base. Please read and follow these instructions carefully and operate the machine accord

This appliance is marked according

to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household was

Air Outlets in the Base

EN 5 INSTALLATION Tumble dryers are supplied to operate at a voltage of 230V, 50 Hz single phase. Check that the supply circuit is rated to at least 6A. Electricity can be extremely dangerous. This appliance must be earthed. The socket outlet and the plug on the appliance must be of the same type. Do not use multiple adapters and/or extension leads. The plug should be accessible for disconnection after the appliance has been install

DRAIN HOSE KIT: FITTING INSTRUCTIONS

WARNING! Switch off and remove the tumble dryer plug from the electricity supply before carrying out any work. Fit the Kit as Follows: 1 . U n s c r e w a n d remove the 3 screws, at the rear of the machine, retaining the worktop trim. 2. Remove the rear worktop trim and the worktop surface by carefully sliding it towards the rear of the machine. 3. The waste water container is situated at the right-hand side of the m

PREPARING THE LOAD

Before using the tumble dryer for the first time: ● Please read this instruction book thoroughly. ● Remove all items packed inside drum. ●Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Check that all fastenings are closed and that poc

Programme Selector – Select the required programme.

Time Selection Button – Allows the user to change duration of the programme selected by Programme Selector. It can be used only with the selection of: Mix&Dry, Shirts and Time Programmes. Delay Start Button – Allows the user to delay the start of the drying cycle (see details of Operation ). Acrylic and Synthetic Button – Anti- Crease Button – Allows the user to select a

Candy Dryer Owners Instructions: