Popp POP_004308 Quick Start Manual

Quick Start S This device is a wireless Z-Wave sensor. Exclusion, Inclusion are confirmed by hitting the programm button for 1 sec when the sensor is removed from the mounting ring and the tamper switch is released. A wakeup is performed hitting the programm button for 1 sec when the sensor is not removed fro ...

4. Sensors directly control actuators 5. Actuators control other actuators 6. Remote controls send signals to static controllers to trigger scenes or other actions 7. Remote controls control other actuators. There are two different role a controller can have. There is always one single prima ...

Place the bracket where you are going to install the detector. In each of keyhole slots, draw a mark to locate plastic anchor and screw. Using a 3/16-inch (5mm) drill bit, drills two holes at the marks and insert plastic anchor, and attached the bracket by using th ...

from the mounting ring and the tamper switch is released. Operating the device Power-on Mode: 1) Install the battery into the module 2) Close the bracket 3) the detector will take 2 to 4 sec. and emit a beep to confirm and start the burglar system. The ...

go to sleep and drains battery faster, but can notify all it's direct neighbors about a wakeup. Node Information Frame NI The Node Information Frame is the business card of a Z-Wave device. It contains information about the device type ...

send unsolicited report. 10 = 1 °C Value Description 0 Disabled (Default) 5 — 50 0.1 °C Temperature shift (Parameter Number 2, Parameter Size 1) Threshold correction. For positive value 10 = 1 °C, for negative value x = 256 - (T°C * 10). Example, if need ...

Sets the temperature High value, if the measurement is higher than this value, Basic ON is sent in temperature association group(2) Value Description 255 Disabled (Default) 0 — 100 °C Command Classes Su ...

Explorer Frame Support Yes SDK 4.55.00 Device Type Slave with routing capabilities Generic Device Class Alarm Sensor Specific Device Class Routing Smoke Sensor Routing No FLiRS No Firmware Version 1.0 Explanation of Z-Wave specific terms Controller — is a Z-Wave device with capabilities to manage the network. Controllers are typical ...