Tarheel Antennas 400A Instruction Manual
Text of the manual
PROUDLY MADE IN THE
UNITED STATES OF AMERICA
Tarheel Antennas, Inc.
Instruction Manual
for the
Model 400A
Continuous Coverage
HF Antenna
18511 CR 304
St. Joseph, MO 64505
816-671-9409 / 816-364-2619 Fax
E-mail: [email protected]
Technical Support
919-552-8788
E-mail: [email protected]
www.tarheelantennas.com
Thank you for purchasing the
Model 400A Tarheel Antenna
Packing List for Model 400A
Model 400A Antenna
6 ft. Stainless Steel Whip
Up/Down Switch
20 ft. Control Cable
Ferrite Core
Fuse Holder & Fuse
1 tube of Dielectric Compound
Manual
Packing List for Model 400A Package
All of the above - - plus the following
MT-1 Antenna Bracket
Quick Disconnect for the Whi
Picture 1 – MT-1 & MT-30FB
Installation
Before installation of this antenna there are a few
things you have to consider. To get peak performance you
need to try to mount the antenna in a location where the
decoupler (this is where the coil comes out of the antenna)
is at least as high as the highest part of the vehicle. Next,
and this is the most important
The MT-1 antenna bracket is designed to make your antenna
mounting convenient and incredibly strong. Made to clamp to
standard 1” pipe (1.312 OD) or bolted to a flat surface.
(Picture 6)
There are a few steps to make sure you
install the MT-1 antenna bracket the way it is
intended. First you need to install the upper
half of the quick disconnect in the bot
Included with the antenna is a special mix
#31 ferrite core that needs to be mounted
on the control wire as close to the
antenna
as
possible.
Loop
the
wire
through the choke at least 3 times.
(Picture 11) It is used to decouple the
control cable from the antenna. If you fail
to install this ferrite core acts like a single
radial and the antenna will be untu
Now You Need To Install The Top Whip
Whip Length versus Frequency Coverage
4 ft. -- 1.8 MHz to 30.0 MHz
5 ft. -- 1.7 MHz to 28.0 MHz
6 ft.-- 1.6 MHz to 26.0 MHz
8 ft.-- 1.5 MHz to 20.0 MHz
12 ft.-- 1.2 MHz to 15.0 MHz
CH-1 -- Capacitance Hat
Hat only -- 1.8 MHz to 30.0 MHz
Hat with 3 ft. whip – 1.6 MHz to 25.0 MHz
Hat with 6 ft. whip – 1.5 MHz to 21.0 MH
Relative Tuning Positions
The following photos will show you relative tuning positions of the Model
400 Tarheel Antennas.
LEXAN COVER REMOVED FOR CLARITY
Model 400 -- full down position with
5 ft. whip -- 28.0 MHz
Model 400 -- 21.2 MHz with 5 ft. whip
Do not try to twist or turn the bug shield on
the outside of the antenna, this is designed
not to turn.
Model 400 -- 14.2 MHz with 5 ft. whip
and 1/2" of coil showing
Model 400 -- 7.1 MHz with 5 ft. whip
and 1 1/2" of coil showing
Model 400 -- 3.9 MHz with 5 ft. whip
and 4" of coil showing
Model 400 -- 3.5 MHz with 5 ft. whip
with 5" of coil showing
Model 400 -- 1.9 MHz with 5 ft. whip
and 15" of coil showing
Model 400 -- 1.8 MHz with 5 ft. whip
and 16 1/2" of